Datir Sandeep P, Mitra Sajal R
Department of Orthopedics, Government Medical College, Nagpur, India.
Spine (Phila Pa 1976). 2004 Jun 1;29(11):1174-81. doi: 10.1097/00007632-200406010-00004.
Morphometric study of the thoracic vertebral pedicular parameters and comparison with the previous studies in the literature.
To define pedicular dimensions and screw placement in the Indian population.
Pedicular morphometric characteristics vary in different population groups. Thoracic pedicular screw fixation is being used more frequently with the advent of better imaging methods. Because of the small size and close proximity to the neurovascular structures, thoracic pedicle fixation has little margin of safety.
T1-T12 vertebral pedicles were studied in 18 cadavers by direct, roentgenographic, and computerized tomographic scan methods. The following parameters were studied: transverse diameter, transverse angle, sagittal diameter, sagittal angle, chord length, interpedicular distance, pedicle entrance point, and pedicle cortical thickness (medial and lateral). RESULTS.: Transverse diameter was more than 6 mm at both ends of the thoracic spine (T1, T2, T11, and T12). Between T3-T9 levels, it was less than 5 mm at some levels. The transverse angle was widest at T1 (30 degrees) and was less than 5 degrees from T5 to T12. Pedicles were directed cephalad in the sagittal plane at all thoracic levels. Sagittal angle was less than 12 degrees at all thoracic levels. Chord length was largest at T11 (37.3 mm) and smallest at T1 and T2 (29.9 mm). Interpedicular distance was 29 mm at T12 and 21.3 mm at T1. Medial pedicular cortex was thicker than lateral cortex at all levels.
These results suggest that even a 4-mm screw should be used carefully at the midthoracic level; 5-mm screw seems to be safe at upper and lower thoracic spine. Because of very small sagittal and transverse angle at mid and lower thoracic levels, the pedicular screw should be inserted along almost perpendicular line in these planes; 25-mm and 30-mm screw length appears to be safe at upper thoracic and lower thoracic levels, respectively. Pedicle entrance point lies along the midtrans-verse line at upper thoracic levels and along the upper border of transverse process at lower thoracic levels.
胸椎椎弓根参数的形态测量研究,并与文献中先前的研究进行比较。
确定印度人群的椎弓根尺寸及螺钉置入情况。
不同人群的椎弓根形态测量特征有所不同。随着更好的成像方法的出现,胸椎椎弓根螺钉固定的应用越来越频繁。由于胸椎椎弓根尺寸小且紧邻神经血管结构,胸椎椎弓根固定的安全 margin 很小。
通过直接、X 线和计算机断层扫描方法对 18 具尸体的 T1 - T12 椎弓根进行研究。研究了以下参数:横径、横角、矢状径、矢状角、弦长、椎弓根间距、椎弓根入口点以及椎弓根皮质厚度(内侧和外侧)。结果:胸椎两端(T1、T2、T11 和 T12)的横径均大于 6mm。在 T3 - T9 节段,某些节段的横径小于 5mm。横角在 T1 处最宽(30 度),从 T5 到 T12 小于 5 度。所有胸椎节段的椎弓根在矢状面均向上倾斜。所有胸椎节段的矢状角均小于 12 度。弦长在 T11 处最大(37.3mm),在 T1 和 T2 处最小(29.9mm)。椎弓根间距在 T12 为 29mm,在 T1 为 21.3mm。所有节段椎弓根内侧皮质均比外侧皮质厚。
这些结果表明,即使在胸段中部使用 4mm 的螺钉也应谨慎;5mm 的螺钉在上胸椎和下胸椎似乎是安全的。由于胸段中部和下部的矢状角和横角非常小,在这些平面应几乎沿垂直线插入椎弓根螺钉;25mm 和 30mm 的螺钉长度分别在上胸椎和下胸椎似乎是安全的。椎弓根入口点在上胸椎节段位于横中线,在下胸椎节段位于横突上缘。