Suppr超能文献

被囊动物纤维素须晶的弹性模量和应力传递特性。

Elastic modulus and stress-transfer properties of tunicate cellulose whiskers.

作者信息

Sturcová Adriana, Davies Geoffrey R, Eichhorn Stephen J

机构信息

Materials Science Centre, School of Materials, University of Manchester, Grosvenor Street, Manchester, M1 7HS United Kingdom.

出版信息

Biomacromolecules. 2005 Mar-Apr;6(2):1055-61. doi: 10.1021/bm049291k.

Abstract

Experimental deformation micromechanics of natural cellulose fibers using Raman spectroscopy and X-ray diffraction have been widely reported. However, little has been published on the direct measurements of the mechanical properties, and in particular the elastic modulus, of the highly crystalline material in the native state. Here we report on measurements of the elastic modulus of tunicate cellulose using a Raman spectroscopic technique. A dispersed sample of the material is deformed using a four-point bending test, and a shift in a characteristic Raman band (located at 1095 cm(-1)) is used as an indication of the stress in the material. Relatively little intensity change of the Raman band located at 1095 cm(-1) is shown to occur for samples oriented parallel and perpendicular to the polarization direction of the laser, as compared to a highly oriented flax sample. This indicates that the tunicate sample is a two-dimensional in-plane random network of fibers. By use of this result, the Raman shift, and calibrations with strain from other materials, it is shown that the modulus of the material is very high, at about 143 GPa, and a lack of Raman band broadening is thought to be due to the fact that there is pure crystalline deformation occurring without the effect of crystalline/amorphous fractions. A strain sensitivity of the shift in the 1095-cm(-1) Raman peak for this specimen is shown to be -2.4 +/- 0.2 cm(-1)/%. A molecular mechanics approach, using computer simulation and an empirical force field, was used to predict the modulus of a highly oriented chain of the material, and this is found to be 145 GPa, which is in agreement with the experimental data. However, by use of a normal-mode analysis, it is found that a number of modes have positions close to the central positions of the experimental Raman band. One in particular is found to shift at a rate of 2.5 cm(-1)/%, but due to the complex nature of the structure, it is not entirely conclusive that this band is representative of the experimental findings.

摘要

利用拉曼光谱和X射线衍射对天然纤维素纤维进行实验变形微观力学研究的报道已颇为广泛。然而,关于直接测量天然状态下高结晶材料的力学性能,尤其是弹性模量的报道却很少。在此,我们报告了使用拉曼光谱技术测量被囊动物纤维素弹性模量的情况。通过四点弯曲试验使该材料的分散样品发生变形,并利用位于1095 cm⁻¹处的特征拉曼峰的位移作为材料应力的指示。与高度取向的亚麻样品相比,对于平行和垂直于激光偏振方向取向的样品,位于1095 cm⁻¹处的拉曼峰强度变化相对较小。这表明被囊动物样品是纤维的二维面内随机网络。利用这一结果、拉曼位移以及与其他材料应变的校准,结果表明该材料的模量非常高,约为143 GPa,并且拉曼峰没有展宽被认为是由于发生了纯晶体变形而没有晶体/非晶部分的影响。该样品在1095 cm⁻¹拉曼峰处的位移应变灵敏度为 -2.4 ± 0.2 cm⁻¹/%。采用分子力学方法,通过计算机模拟和经验力场来预测该材料高度取向链的模量,结果发现为145 GPa,这与实验数据相符。然而,通过使用简正模式分析,发现一些模式的位置接近实验拉曼峰的中心位置。特别发现其中一个模式以2.5 cm⁻¹/%的速率位移,但由于结构的复杂性,不能完全确定该峰代表实验结果。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验