Díaz Eva, Muñoz Emilio, Vega Aurelio, Ordóñez Salvador
Department of Chemical Engineering and Environmental Technology, University of Oviedo, Julián Clavería s/n, 33006 Oviedo, Spain.
Chemosphere. 2008 Feb;70(8):1375-82. doi: 10.1016/j.chemosphere.2007.09.034. Epub 2007 Oct 30.
Adsorption of carbon dioxide on alkaline modified X zeolites was investigated by temperature programmed desorption (TPD) analysis of these materials previously saturated with CO(2) at 50, 100 and 200 degrees C. Parent X zeolite (in its sodium form) was treated with different sodium and cesium aqueous solutions, using both carbonates and hydroxides as precursors. The resulting materials were characterised by nitrogen physisorption, XRD, and NH(3)-TPD, in order to determine their morphological, crystallographic and chemical properties. Slight desilication phenomena were observed using hydroxides as precursors, whereas the treatment with Cs salts lead to higher crystallinity losses. Several successive adsorption-desorption cycles were carried out in order to check the regenerability of the adsorbents. Cesium-treated zeolites present higher carbon dioxide retention capacities than the sodium treated and than the parent material. When working with these Cs-modified materials, the desorption takes place mainly at temperatures between 250 and 400 degrees C, results of great practical interest, since it allows the use these kinds of materials for adsorption-desorption cycles. The evolution of the retention capacity with temperature is also markedly more positive for Cs-treated zeolite, especially when carbonate is used as the precursor. These materials maintain high retention capacities at 100 degrees C (10mg g(-1)) and even at 200 degrees C (3mg g(-1)), temperatures at which the most of the adsorbents are inactive.
通过对预先在50、100和200℃下用CO₂饱和的这些材料进行程序升温脱附(TPD)分析,研究了二氧化碳在碱性改性X型沸石上的吸附情况。母体X型沸石(钠型)用不同的钠和铯水溶液处理,使用碳酸盐和氢氧化物作为前驱体。通过氮气物理吸附、XRD和NH₃-TPD对所得材料进行表征,以确定它们的形态、晶体结构和化学性质。以前驱体为氢氧化物时观察到轻微的脱硅现象,而用铯盐处理导致更高的结晶度损失。进行了几个连续的吸附-脱附循环以检查吸附剂的可再生性。铯处理的沸石比钠处理的和母体材料具有更高的二氧化碳保留能力。当使用这些铯改性材料时,脱附主要发生在250至400℃之间的温度,这是非常具有实际意义的结果,因为这允许将这些类型的材料用于吸附-脱附循环。对于铯处理的沸石,保留能力随温度的变化也明显更有利,特别是当前驱体为碳酸盐时。这些材料在100℃(10mg g⁻¹)甚至在200℃(3mg g⁻¹)时保持高保留能力,而在这些温度下大多数吸附剂是无活性的。