Whittington Alan G, Hofmeister Anne M, Nabelek Peter I
Department of Geological Sciences, University of Missouri, Columbia, Missouri 65211, USA.
Nature. 2009 Mar 19;458(7236):319-21. doi: 10.1038/nature07818.
The thermal evolution of planetary crust and lithosphere is largely governed by the rate of heat transfer by conduction. The governing physical properties are thermal diffusivity (kappa) and conductivity (k = kapparhoC(P)), where rho denotes density and C(P) denotes specific heat capacity at constant pressure. Although for crustal rocks both kappa and k decrease above ambient temperature, most thermal models of the Earth's lithosphere assume constant values for kappa ( approximately 1 mm(2) s(-1)) and/or k ( approximately 3 to 5 W m(-1) K(-1)) owing to the large experimental uncertainties associated with conventional contact methods at high temperatures. Recent advances in laser-flash analysis permit accurate (+/-2 per cent) measurements on minerals and rocks to geologically relevant temperatures. Here we provide data from laser-flash analysis for three different crustal rock types, showing that kappa strongly decreases from 1.5-2.5 mm(2) s(-1) at ambient conditions, approaching 0.5 mm(2) s(-1) at mid-crustal temperatures. The latter value is approximately half that commonly assumed, and hot middle to lower crust is therefore a much more effective thermal insulator than previously thought. Above the quartz alpha-beta phase transition, crustal kappa is nearly independent of temperature, and similar to that of mantle materials. Calculated values of k indicate that its negative dependence on temperature is smaller than that of kappa, owing to the increase of C(P) with increasing temperature, but k also diminishes by 50 per cent from the surface to the quartz alpha-beta transition. We present models of lithospheric thermal evolution during continental collision and demonstrate that the temperature dependence of kappa and C(P) leads to positive feedback between strain heating in shear zones and more efficient thermal insulation, removing the requirement for unusually high radiogenic heat production to achieve crustal melting temperatures. Positive feedback between heating, increased thermal insulation and partial melting is predicted to occur in many tectonic settings, and in both the crust and the mantle, facilitating crustal reworking and planetary differentiation.
行星地壳和岩石圈的热演化在很大程度上受传导热传递速率的控制。起控制作用的物理性质是热扩散率(κ)和热导率(k = κρC(P)),其中ρ表示密度,C(P)表示恒压比热容。尽管对于地壳岩石,κ和k在高于环境温度时都会降低,但由于与高温下传统接触方法相关的巨大实验不确定性,大多数地球岩石圈的热模型都假定κ(约1平方毫米每秒)和/或k(约3至5瓦每米开尔文)为恒定值。激光闪光分析的最新进展使得能够在与地质相关的温度下对矿物和岩石进行精确(±2%)测量。在此,我们提供了三种不同地壳岩石类型的激光闪光分析数据,表明κ在环境条件下从1.5 - 2.5平方毫米每秒大幅降低,在中地壳温度下接近0.5平方毫米每秒。后一个值约为通常假定值的一半,因此热的中地壳到下地壳是比以前认为的更有效的热绝缘体。在石英α - β相变温度以上,地壳的κ几乎与温度无关,且与地幔物质的κ相似。k的计算值表明,由于C(P)随温度升高而增加,其对温度的负依赖性小于κ,但k从地表到石英α - β相变也会降低50%。我们展示了大陆碰撞过程中岩石圈热演化的模型,并证明κ和C(P)对温度的依赖性导致剪切带应变加热与更有效的热绝缘之间产生正反馈,从而无需异常高的放射性热产生就能达到地壳熔化温度。加热、热绝缘增加和部分熔化之间的正反馈预计会在许多构造环境中以及地壳和地幔中发生,促进地壳改造和行星分异。