Gan Kok Beng, Zahedi Edmond, Mohd Ali Mohd Alauddin
Department of Electrical, Electronic, and Systems Engineering, Faculty of Engineering and Built Environment, Universiti KebangsaanMalaysia, Bangi, Malaysia.
IEEE Trans Biomed Eng. 2009 Aug;56(8):2075-82. doi: 10.1109/TBME.2009.2021578. Epub 2009 Apr 28.
In obstetrics, fetal heart rate (FHR) detection remains the standard for intrapartum assessment of fetal well-being. In this paper, a low-power (< 55 mW) optical technique is proposed for transabdominal FHR detection using near-infrared photoplesthysmography (PPG). A beam of IR-LED (890 nm) propagates through to the maternal abdomen and fetal tissues, resulting in a mixed signal detected by a low-noise detector situated at a distance of 4 cm. Low-noise amplification and 24-bit analog-to-digital converter resolution ensure minimum effect of quantization noise. After synchronous detection, the mixed signal is processed by an adaptive filter to extract the fetal signal, whereas the PPG from the mother's index finger is the reference input. A total of 24 datasets were acquired from six subjects at 37 +/- 2 gestational weeks. Results show a correlation coefficient of 0.96 (p-value < 0.001) between the proposed optical and ultrasound FHR, with a maximum error of 4%. Assessment of the effect of probe position on detection accuracy indicates that the probe should be close to fetal tissues, but not necessarily restricted to head or buttocks.
在产科中,胎儿心率(FHR)检测仍然是产时评估胎儿健康状况的标准方法。本文提出了一种低功耗(<55 mW)的光学技术,用于使用近红外光电容积脉搏波描记法(PPG)进行经腹胎儿心率检测。一束红外发光二极管(890 nm)的光束穿过母体腹部和胎儿组织,由位于4 cm处的低噪声探测器检测到混合信号。低噪声放大和24位模数转换器分辨率可确保量化噪声的影响最小。同步检测后,混合信号由自适应滤波器处理以提取胎儿信号,而来自母亲食指的PPG作为参考输入。从6名孕37±2周的受试者身上共采集了24个数据集。结果表明,所提出的光学方法与超声检测的胎儿心率之间的相关系数为0.96(p值<0.001),最大误差为4%。对探头位置对检测准确性影响的评估表明,探头应靠近胎儿组织,但不一定局限于头部或臀部。