Department of Mechanical Engineering, Center of Technological Science, State University of Santa Catarina, Campus Universitario, Bairro Bom Retiro, 631, Joinville 89223-100, SC, Brazil.
J Mater Sci Mater Med. 2010 Jul;21(7):2035-47. doi: 10.1007/s10856-010-4074-9.
A simplified simulated body fluid solution (S-SBF) was used to study the kinetics and mechanism of nucleation and growth of octacalcium phosphate (OCP) on the surfaces of alkali and heat-treated titanium samples. After the alkali and heat treatments, the samples were soaked in S-SBF for periods varying up to 24 h. A thin layer of poorly crystallized calcium titanate was formed after 15 min of immersion, allowing for the deposition of another layer of amorphous calcium phosphate (ACP). After 2.5 h of immersion, OCP nuclei were observed on the surface of the ACP layer. After 5 h of immersion in S-SBF solution, the specimens were completely covered with a homogeneous plate-like layer of OCP. Analyses by transmission electron microscopy revealed that nucleation and growth of OCP occurred concomitantly to the crystallization of ACP in hydroxyapatite (HA). This transformation took place by solid-state diffusion, forming a needle-like HA structure underneath the OCP film.
采用简化的模拟体液溶液(S-SBF)研究了八钙磷酸盐(OCP)在碱处理和热处理钛样品表面成核和生长的动力学和机理。碱处理和热处理后,将样品在 S-SBF 中浸泡长达 24 小时。浸泡 15 分钟后形成一层结晶不良的钛酸钙,允许沉积另一层无定形磷酸钙(ACP)。浸泡 2.5 小时后,在 ACP 层表面观察到 OCP 核。浸泡在 S-SBF 溶液 5 小时后,样品完全被一层均匀的板状 OCP 覆盖。透射电子显微镜分析表明,OCP 的成核和生长与羟基磷灰石(HA)中 ACP 的结晶同时发生。这种转变通过固态扩散发生,在 OCP 膜下形成针状 HA 结构。