Barone Antonio, Ricci Massimiliano, Tonelli Paolo, Santini Stefano, Covani Ugo
Department of Surgery, University of Pisa, Pisa, Italy; Istituto Stomatologico Tirreno, Versilia General Hospital, Lido di Camaiore (LU), Italy.
Clin Oral Implants Res. 2013 Nov;24(11):1231-7. doi: 10.1111/j.1600-0501.2012.02535.x. Epub 2012 Jul 12.
As a consequence of extraction, the height of the buccal wall tends to decrease and results in the disappearance of bundle bone. To modify bone remodelling after extraction, various ridge preservation techniques have been proposed. The present research was drawn up with the following considerations in mind: to evaluate and to compare changes of hard and soft tissues in post-extraction sockets which received a ridge preservation procedure, with post-extraction sockets which had healed naturally.
Each patient was randomly allocated to a test or control group using a specific software package. After extraction, the sockets were carefully inspected and any granulation tissue was removed. The control sites received silk sutures to stabilize the clot without any grafting material. The test sites were grafted with corticocancellous porcine bone and a collagen membrane. All experimental sites had the membranes left exposed to the oral cavity with a secondary wound healing. The thickness of the buccal alveolar bone, if present, was carefully measured at the time of tooth extraction using a calliper at 1 mm from the edge of the wall. The following clinical parameters were evaluated at baseline and after 4 months at implant placement: vertical bone changes, horizontal bone changes and width of keratinized gingiva. The length, diameter and need for additional bone augmentation were assessed for both groups at the time of implant insertion.
The control group showed vertical bone resorption of 1 ± 0.7 mm, 2.1 ± 0.6 mm, 1 ± 0.8 mm and 2 ± 0.73 mm at the mesial, vestibular, distal and lingual sites respectively. Moreover, changes in horizontal dimension showed an average resorption of 3.6 ± 0.72 mm. The test sites showed a horizontal bone remodelling of 0.3 ± 0.76 mm, 1.1 ± 0.96 mm, 0.3 ± 0.85 mm, 0.9 ± 0.98 mm at the mesial, vestibular, distal and lingual sites respectively. The horizontal bone resorption at the test sites was 1.6 ± 0.55 mm. The keratinized gingiva showed a coronal shift of 0.7 mm in the control group when compared to 1.1 mm in the test group. In addition, 42% of sites in the control group required an additional bone augmentation at implant placement, when compared to 7% in the test sites.
This study clearly points out that an alveolar ridge preservation technique performed with collagenated porcine bone and a resorbable membrane--according to the procedure reported in this study--was able to limit the contour changes after tooth extraction. Finally, the test sites showed a better preservation of facial keratinized tissue when compared to control sites; grafted sites allowed the placement of longer and wider implants when compared to implants inserted in non-grafted sites.
拔牙后,颊侧骨壁高度往往会降低,导致束状骨消失。为改变拔牙后的骨重塑,人们提出了多种牙槽嵴保存技术。本研究基于以下考虑展开:评估并比较接受牙槽嵴保存术的拔牙后牙槽窝与自然愈合的拔牙后牙槽窝软硬组织的变化。
使用特定软件包将每位患者随机分配至试验组或对照组。拔牙后,仔细检查牙槽窝并清除任何肉芽组织。对照组创口用丝线缝合以稳定血凝块,不使用任何移植材料。试验组创口植入皮质松质猪骨和胶原膜。所有试验部位的膜均暴露于口腔,通过二期愈合。拔牙时,使用卡尺在距骨壁边缘1毫米处仔细测量颊侧牙槽骨的厚度(若存在)。在基线以及植入种植体前4个月时评估以下临床参数:垂直骨变化、水平骨变化和角化龈宽度。在植入种植体时评估两组的种植体长径、直径以及是否需要额外的骨增量。
对照组在近中、前庭、远中和舌侧部位的垂直骨吸收分别为1±0.7毫米、2.1±0.6毫米、1±0.8毫米和2±0.73毫米。此外,水平方向尺寸变化显示平均吸收3.6±0.72毫米。试验组在近中、前庭、远中和舌侧部位的水平骨重塑分别为0.3±0.76毫米、1.1±0.96毫米、0.3±0.85毫米、0.9±0.98毫米。试验组的水平骨吸收为1.6±0.55毫米。与试验组的1.1毫米相比,对照组的角化龈出现了0.7毫米的冠向移位。此外,对照组42%的部位在植入种植体时需要额外的骨增量,而试验组为7%。
本研究明确指出,根据本研究报告的操作流程,采用胶原化猪骨和可吸收膜进行的牙槽嵴保存技术能够限制拔牙后的外形变化。最后,与对照组相比,试验组对面部角化组织的保存效果更好;与植入未移植部位的种植体相比,移植部位能够植入更长、更宽的种植体。