Applied Microbiology Laboratory, Centre for Rural Development and Technology, Indian Institute of Technology Delhi, Hauz Khas, New Delhi 110016, India.
Environ Sci Pollut Res Int. 2013 May;20(5):2882-92. doi: 10.1007/s11356-012-1190-8. Epub 2012 Sep 21.
Dyes used in various industries are discharged into the environment and pose major environmental concern. In the present study, fungal isolate Aspergillus lentulus was utilized for the treatment of various dyes, dye mixtures and dye containing effluent in dual modes, bioaccumulation (employing growing biomass) and biosorption (employing pre-cultivated biomass). The effect of dye toxicity on the growth of the fungal isolate was studied through phase contrast and scanning electron microscopy. Dye biosorption was studied using first and second-order kinetic models. Effects of factors influencing adsorption and isotherm studies were also conducted. During bioaccumulation, good removal was obtained for anionic dyes (100 mg/l), viz. Acid Navy Blue, Fast Red A and Orange-HF dye (99.4 %, 98.8 % and 98.7 %, respectively) in 48 h. Cationic dyes (10 mg/l), viz. Rhodamine B and Methylene Blue, had low removal efficiency (80.3 % [48 h] and 92.7 % [144 h], respectively) as compared to anionic dyes. In addition to this, fungal isolate showed toxicity response towards Methylene Blue by producing larger aggregates of fungal pellets. To overcome the limitations of bioaccumulation, dye removal in biosorption mode was studied. In this mode, significant removal was observed for anionic (96.7-94.3 %) and cationic (35.4-90.9 %) dyes in 24 h. The removal of three anionic dyes and Rhodamine B followed first-order kinetic model whereas removal of Methylene Blue followed second-order kinetic model. Overall, fungal isolate could remove more than 90 % dye from different dye mixtures in bioaccumulation mode and more than 70 % dye in biosorption mode. Moreover, significant color removal from handmade paper unit effluent in bioaccumulation mode (86.4 %) as well as in biosorption mode (77.1 %) was obtained within 24 h. This study validates the potential of fungal isolate, A. lentulus, to be used as the primary organism for treating dye containing wastewater.
用于各种工业的染料被排放到环境中,对环境构成了重大的关注。在本研究中,真菌分离株 Aspergillus lentulus 被用于以生物积累(使用生长的生物质)和生物吸附(使用预培养的生物质)两种模式处理各种染料、染料混合物和含染料的废水。通过相差和扫描电子显微镜研究了染料毒性对真菌分离株生长的影响。通过一级和二级动力学模型研究了染料的生物吸附。还进行了影响吸附的因素和等温线研究。在生物积累过程中,对于阴离子染料(100mg/L),如酸性海军蓝、快速红 A 和橙色-HF 染料,在 48 小时内获得了良好的去除效果(分别为 99.4%、98.8%和 98.7%)。对于阳离子染料(10mg/L),如罗丹明 B 和亚甲蓝,去除效率较低(分别为 80.3%[48 小时]和 92.7%[144 小时]),与阴离子染料相比。除此之外,真菌分离株对亚甲蓝表现出毒性反应,导致真菌颗粒形成更大的聚集体。为了克服生物积累的局限性,研究了在生物吸附模式下的染料去除。在这种模式下,在 24 小时内,对阴离子(96.7-94.3%)和阳离子(35.4-90.9%)染料的去除率显著。三种阴离子染料和罗丹明 B 的去除遵循一级动力学模型,而亚甲蓝的去除遵循二级动力学模型。总的来说,真菌分离株在生物积累模式下可以去除 90%以上的不同染料混合物中的染料,在生物吸附模式下可以去除 70%以上的染料。此外,在 24 小时内,在生物积累模式(86.4%)和生物吸附模式(77.1%)中,从手工造纸装置废水中获得了显著的颜色去除效果。本研究验证了真菌分离株 Aspergillus lentulus 作为处理含染料废水的原始生物的潜力。