Sina S, Faghihi R, Meigooni A S
Radiation Research Center, School of mechanical engineering, Shiraz University, Shiraz, Iran.
Radiation Research Center, School of mechanical engineering, Shiraz University, Shiraz, Iran ; Nuclear Engineering department, School of mechanical engineering, Shiraz University, Shiraz, Iran.
J Biomed Phys Eng. 2015 Jun 1;5(2):53-8. eCollection 2015 Jun.
Most of the current brachytherapy treatment planning systems (TPS) use the TG-43U1 recommendations for dosimetry in water phantom, not considering the heterogeneity effects.
The purpose of this study is developing a method for obtaining correction factors for heterogeneity for Cs-137 brachytherapy sources based on pre-calculated MC simulations and interpolation.
To simulate the effect of phantom heterogeneity on dose distribution around Cs-137 sources, spherical water phantoms were simulated in which there were spherical shells of bone with different thicknesses (0.2cm to 1.8cm with 0.1cm increment) at different distances (from 0.1cm to 10cm, with 0.5cm increment) from the source center. The spherical shells with 0.1cm thickness at different distances from 0.1cm to 10cm were used as tally cells. The doses at these cells were obtained by tally types F6, *F8, and *F4.The results indicate that the percentage differences between the doses in heterogeneity sections with the dose at the same positions inside the homogeneous water phantom vary when the distance of bone section from the source center increases, because of decreasing the average energy of photons reaching the bone layer. Finally, the results of Monte Carlo simulations were used as the input data of MATLAB software, and the percentage dose difference for each new configuration (i.e. different thickness of inhomogenity at different distances from the source) was estimated using the 2D interpolation of MATLAB.
According to the results, the algorithm used in this study, is capable of dose estimation with high accuracy.
The developed method using the results of Monte Carlo simulations and the dose interpolation can be used in treatment planning systems for heterogeneity corrections.
当前大多数近距离放射治疗治疗计划系统(TPS)在水模体剂量计算中采用TG-43U1建议,未考虑非均匀性效应。
本研究旨在基于预先计算的蒙特卡罗模拟和插值法,开发一种获取铯-137近距离放射源非均匀性校正因子的方法。
为模拟模体非均匀性对铯-137源周围剂量分布的影响,对球形水模体进行模拟,其中在距源中心不同距离(从0.1cm至10cm,增量为0.5cm)处有不同厚度(从0.2cm至1.8cm,增量为0.1cm)的球形骨壳。将距源中心0.1cm至10cm不同距离处厚度为0.1cm的球形壳用作 tally 单元。通过 tally 类型F6、F8和F4获取这些单元处的剂量。结果表明,由于到达骨层的光子平均能量降低,当骨截面距源中心的距离增加时,非均匀性截面中的剂量与均匀水模体中相同位置处剂量之间的百分比差异会发生变化。最后,将蒙特卡罗模拟结果用作MATLAB软件的输入数据,并使用MATLAB的二维插值法估计每个新配置(即距源不同距离处的不同非均匀性厚度)的剂量百分比差异。
根据结果,本研究中使用的算法能够高精度地进行剂量估计。
所开发的利用蒙特卡罗模拟结果和剂量插值的方法可用于治疗计划系统中的非均匀性校正。