Nasser Al-Shorgani Najeeb Kaid, Kalil Mohd Sahaid, Wan Yusoff Wan Mohtar, Shukor Hafiza, Hamid Aidil Abdul
School of Bioscience and Biotechnology, Faculty of Science and Technology, Universiti Kebangsaan Malaysia, 43600 UKM, Bangi, Selangor, Malaysia; Department of Applied Microbiology, Faculty of Applied Sciences, Taiz University, 6803, Taiz, Yemen.
Department of Chemical and Process Engineering, Faculty of Engineering, Universiti Kebangsaan Malaysia, 43600 UKM, Bangi, Selangor, Malaysia.
Anaerobe. 2015 Dec;36:65-72. doi: 10.1016/j.anaerobe.2015.09.008. Epub 2015 Oct 9.
Improvement in the butanol production selectivity or enhanced butanol:acetone ratio (B:A) is desirable in acetone-butanol-ethanol (ABE) fermentation by Clostridium strains. In this study, artificial electron carriers were added to the fermentation medium of a new isolate of Clostridium acetobutylicum YM1 in order to improve the butanol yield and B:A ratio. The results revealed that medium supplementation with electron carriers changed the metabolism flux of electron and carbon in ABE fermentation by YM1. A decrease in acetone production, which subsequently improved the B:A ratio, was observed. Further improvement in the butanol production and B:A ratios were obtained when the fermentation medium was supplemented with butyric acid. The maximum butanol production (18.20 ± 1.38 g/L) was gained when a combination of methyl red and butyric acid was added. Although the addition of benzyl viologen (0.1 mM) and butyric acid resulted in high a B:A ratio of 16:1 (800% increment compared with the conventional 2:1 ratio), the addition of benzyl viologen to the culture after 4 h resulted in the production of 18.05 g/L butanol. Manipulating the metabolic flux to butanol through the addition of electron carriers could become an alternative strategy to achieve higher butanol productivity and improve the B:A ratio.
在丙酮丁醇梭菌菌株进行的丙酮-丁醇-乙醇(ABE)发酵中,提高丁醇生产选择性或提高丁醇与丙酮比例(B:A)是很有必要的。在本研究中,向丙酮丁醇梭菌新分离株YM1的发酵培养基中添加人工电子载体,以提高丁醇产量和B:A比例。结果表明,向培养基中添加电子载体改变了YM1在ABE发酵中的电子和碳代谢通量。观察到丙酮产量下降,随后提高了B:A比例。当发酵培养基中添加丁酸时,丁醇产量和B:A比例进一步提高。添加甲基红和丁酸的组合时,获得了最大丁醇产量(18.20±1.38 g/L)。虽然添加苄基紫精(0.1 mM)和丁酸导致B:A比例高达16:1(与传统的2:1比例相比增加了800%),但在4小时后向培养物中添加苄基紫精导致丁醇产量达到18.05 g/L。通过添加电子载体来操纵通向丁醇的代谢通量可能成为实现更高丁醇生产率和提高B:A比例的替代策略。