Choi Kwangseok, Taghavivand Milad, Zhang Lifeng
Electrical Safety Research Group, National Institute of Occupational Safety and Health, Tokyo, Japan; Department of Chemical and Biological Engineering, University of Saskatchewan, Saskatoon, Canada.
Department of Chemical and Biological Engineering, University of Saskatchewan, Saskatoon, Canada.
Int J Pharm. 2017 Mar 15;519(1-2):98-103. doi: 10.1016/j.ijpharm.2017.01.005. Epub 2017 Jan 3.
Pharmaceutical powders are mainly organic materials and are likely to be charged due to repeated inter-particle and particle-wall contacts during industrial processes. This study experimentally investigated the effect of moisture content (ranging from approximately 1.8 to 30wt.%) on tribocharging behaviour of pharmaceutical granules, as well as their apparent volume resistivity. The tribocharging behaviour of pharmaceutical granules was investigated using a rotating device and apparent volume resistivity was measured in a conventional volume resistivity test cell. Additional measurements were performed on individual ingredients, each having the same moisture content as that of the granules, in order to investigate the effect of each single ingredient on the apparent volume resistivity of granules. In this work, the individual ingredients used for granules were: α-Lactose Monohydrate (α-LMH), Microcrystalline Cellulose (MCC), Hydroxypropyl Methylcellulose (HPMC), and Croscarmellose Sodium (CCS). The results showed that the specific charge of granules began to increase at the moisture contents below 5wt.%, which can be referred as critical moisture content of granules. The apparent volume resistivity showed the same behaviour, indicating that the specific charge could be due to an increase in apparent volume resistivity of granules at reduced moisture content. Finally, it was shown that the apparent volume resistivity measured for granules was mainly affected by that of the α-LMH, the major component of granules accounting for 40wt.%.
药用粉末主要是有机材料,在工业过程中,由于颗粒间和颗粒与器壁的反复接触,它们很可能会带电。本研究通过实验研究了水分含量(约1.8%至30wt.%)对药用颗粒摩擦起电行为及其表观体积电阻率的影响。使用旋转装置研究了药用颗粒的摩擦起电行为,并在传统的体积电阻率测试池中测量了表观体积电阻率。对每种成分进行了额外测量,每种成分的水分含量与颗粒相同,以研究每种单一成分对颗粒表观体积电阻率的影响。在这项工作中,用于颗粒的单一成分有:一水合α-乳糖(α-LMH)、微晶纤维素(MCC)、羟丙基甲基纤维素(HPMC)和交联羧甲基纤维素钠(CCS)。结果表明,颗粒的比电荷在水分含量低于5wt.%时开始增加,这可称为颗粒的临界水分含量。表观体积电阻率表现出相同的行为,表明比电荷可能是由于颗粒在水分含量降低时表观体积电阻率增加所致。最后,结果表明,颗粒的表观体积电阻率主要受α-LMH的影响,α-LMH是颗粒的主要成分,占40wt.%。