Suppr超能文献

维持创伤患者 CT 检查时的固定装置:一项可行性研究。

Maintaining immobilisation devices on trauma patients during CT: a feasibility study.

机构信息

Department of Radiology, Sørlandet Hospital Kristiansand, Kristiansand, Norway.

Clinic for Medical Services, Sørlandet Hospital Kristiansand, Kristiansand, Norway.

出版信息

Scand J Trauma Resusc Emerg Med. 2017 Aug 23;25(1):84. doi: 10.1186/s13049-017-0428-3.

Abstract

BACKGROUND

To reduce the possibility of secondary deterioration of spinal injuries, it is desirable to maintain the spinal immobilisation that is applied in the prehospital setting throughout computed tomography (CT) scanning. A previous study found that metallic components within the inflation valve of the vacuum mattresses caused CT artefacts. The aim of our study was to investigate the effect of vacuum mattresses with plastic valves on CT artefacts, the radiation dose, and noise compared to a trauma transfer board and the spine boards currently used in our trauma system.

METHODS

We scanned an anthropomorphic whole body phantom with different immobilisation devices on a 128-slice CT scanner using the standard polytrauma CT-protocol at our institution. The phantom was scanned without any immobilisation device and with three different vacuum mattresses, two spine boards, and one trauma transfer board. Two radiologists independently assessed the artefacts. Agreement between the two radiologists was measured using the kappa coefficient. The radiation dose and noise were assessed.

RESULTS

One spine board produced major artefacts due to its metal components. One of the vacuum mattresses resulted in artefacts that impaired clinical judgement. Otherwise, the artefacts predominantly did not impede clinical judgement and were mainly subtle. One of the vacuum mattresses resulted in no artefacts that affected clinical judgement. The overall inter-rater agreement was substantial (0.86, kappa 0.77). We did not observe any artefacts due to plastic valves. The mean CT radiation dose was slightly higher for two of the devices in the head series than that for the trauma transfer board, used as the standard in our system. Only marginal differences were noted for the other devices and series. Small differences in image noise were found between the devices.

CONCLUSIONS

Our results indicate that it is feasible to maintain some vacuum mattresses with plastic valves on trauma patients during CT scanning. The tested mattresses did not result in a considerably increased radiation dose or artefacts that hampered clinical judgement. One of the tested vacuum mattresses produced no artefacts that hampered clinical judgement whatsoever.

摘要

背景

为了降低脊柱损伤继发恶化的可能性,在进行计算机断层扫描(CT)时,理想情况下应维持院前固定所用的脊柱固定。此前的研究发现,充气阀内的金属部件会导致真空床垫产生 CT 伪影。本研究旨在调查与当前在创伤系统中使用的创伤转运板和脊柱板相比,带有塑料阀的真空床垫对 CT 伪影、辐射剂量和噪声的影响。

方法

我们在机构的 128 层 CT 扫描仪上使用标准多发伤 CT 方案对具有不同固定装置的人体全身模拟物进行扫描。模拟物在无任何固定装置和三种不同真空床垫、两块脊柱板和一块创伤转运板的情况下进行扫描。两名放射科医生独立评估伪影。使用 Kappa 系数测量两位放射科医生之间的一致性。评估辐射剂量和噪声。

结果

一块脊柱板因其金属部件而产生严重伪影。其中一个真空床垫产生的伪影影响临床判断。否则,伪影主要不会妨碍临床判断,且主要为细微伪影。一个真空床垫没有产生任何影响临床判断的伪影。总体观察者间一致性为高度一致(0.86,Kappa 值 0.77)。我们未观察到任何由塑料阀引起的伪影。两个设备在头部系列的 CT 辐射剂量略高于创伤转运板,后者是我们系统中的标准。其他设备和系列仅略有差异。设备之间的图像噪声存在微小差异。

结论

我们的结果表明,在 CT 扫描期间维持一些带有塑料阀的真空床垫固定创伤患者是可行的。所测试的床垫不会导致辐射剂量显著增加或妨碍临床判断的伪影。其中一个测试的真空床垫没有产生任何妨碍临床判断的伪影。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验