California Institute of Technology, Department of Electrical Engineering, Pasadena, California, United States.
J Biomed Opt. 2020 Feb;25(2):1-12. doi: 10.1117/1.JBO.25.2.025002.
Ultrasound-assisted optical imaging techniques, such as ultrasound-modulated optical tomography, allow for imaging deep inside scattering media. In these modalities, a fraction of the photons passing through the ultrasound beam is modulated. The efficiency by which the photons are converted is typically referred to as the ultrasound modulation's "tagging efficiency." Interestingly, this efficiency has been defined in varied and discrepant fashion throughout the scientific literature.
The aim of this study is the ultrasound tagging efficiency in a manner consistent with its definition and experimentally verify the contributive (or noncontributive) relationship between the mechanisms involved in the ultrasound optical modulation process.
We adopt a general description of the tagging efficiency as the fraction of photons traversing an ultrasound beam that is frequency shifted (inclusion of all frequency-shifted components). We then systematically studied the impact of ultrasound pressure and frequency on the tagging efficiency through a balanced detection measurement system that measured the power of each order of the ultrasound tagged light, as well as the power of the unmodulated light component.
Through our experiments, we showed that the tagging efficiency can reach 70% in a scattering phantom with a scattering anisotropy of 0.9 and a scattering coefficient of 4 mm - 1 for a 1-MHz ultrasound with a relatively low (and biomedically acceptable) peak pressure of 0.47 MPa. Furthermore, we experimentally confirmed that the two ultrasound-induced light modulation mechanisms, particle displacement and refractive index change, act in opposition to each other.
Tagging efficiency was quantified via simulation and experiments. These findings reveal avenues of investigation that may help improve ultrasound-assisted optical imaging techniques.
超声辅助光学成像技术,如超声调制光学层析成像,允许对散射介质内部进行成像。在这些模式中,通过超声束的部分光子会被调制。光子被转换的效率通常被称为超声调制的“标记效率”。有趣的是,这种效率在整个科学文献中被以不同的和不一致的方式定义。
本研究的目的是以与定义一致的方式确定超声标记效率,并通过实验验证超声光学调制过程中涉及的机制的贡献(或非贡献)关系。
我们采用标记效率的一般描述,即穿过超声束的光子频率偏移的分数(包括所有频率偏移分量)。然后,我们通过平衡检测测量系统系统地研究了超声压力和频率对标记效率的影响,该系统测量了每个阶次的超声标记光的功率以及未调制光分量的功率。
通过实验,我们表明在散射各向异性为 0.9、散射系数为 4mm-1 的散射体中,对于峰值压力相对较低(且在生物医学上可接受)的 0.47MPa 的 1MHz 超声,标记效率可达到 70%。此外,我们通过实验证实了两种超声诱导的光调制机制,即颗粒位移和折射率变化,相互作用相反。
通过模拟和实验对标记效率进行了量化。这些发现为可能有助于改进超声辅助光学成像技术的研究途径提供了线索。