College of Automotive and Mechanical Engineering, Changsha University of Science and Technology, Changsha 410114, China.
Molecules. 2021 Jul 1;26(13):4030. doi: 10.3390/molecules26134030.
The diffusion behavior of fluid water in nanochannels with hydroxylation of silica gel and silanization of different modified chain lengths was simulated by the equilibrium molecular dynamics method. The diffusion coefficient of fluid water was calculated by the Einstein method and the Green-Kubo method, so as to analyze the change rule between the modification degree of nanochannels and the diffusion coefficient of fluid water. The results showed that the diffusion coefficient of fluid water increased with the length of the modified chain. The average diffusion coefficient of fluid water in the hydroxylated nanochannels was 8.01% of the bulk water diffusion coefficient, and the diffusion coefficients of fluid water in the -(CH)CH, -(CH)CH, and -(CH)CH nanochannels were 44.10%, 49.72%, and 53.80% of the diffusion coefficients of bulk water, respectively. In the above four wall characteristic models, the diffusion coefficients in the direction were smaller than those in the other directions. However, with an increase in the silylation degree, the increased self-diffusion coefficient due to the surface effect could basically offset the decreased self-diffusion coefficient owing to the scale effect. In the four nanochannels, when the local diffusion coefficient of fluid water was in the range of 8 Å close to the wall, Dz was greater than Dxy, and beyond the range of 8 Å of the wall, the Dz was smaller than Dxy.
采用平衡分子动力学方法模拟了硅胶羟化和不同链长硅烷化的纳米通道中流体水的扩散行为。采用爱因斯坦方法和格林-库伯方法计算了流体水的扩散系数,从而分析纳米通道的修饰程度与流体水扩散系数之间的变化规律。结果表明,流体水的扩散系数随修饰链长度的增加而增加。在羟化纳米通道中,流体水的平均扩散系数为体相水扩散系数的 8.01%,而在-(CH)CH、-(CH)CH 和-(CH)CH 纳米通道中,流体水的扩散系数分别为体相水扩散系数的 44.10%、49.72%和 53.80%。在上述四个壁特征模型中,方向的扩散系数小于其他方向的扩散系数。然而,随着硅烷化程度的增加,由于表面效应引起的自扩散系数的增加基本上可以抵消由于尺度效应引起的自扩散系数的降低。在四个纳米通道中,当流体水的局部扩散系数在接近壁面的 8 Å 范围内时,Dz 大于 Dxy,而在壁面 8 Å 的范围之外,Dz 小于 Dxy。