Suppr超能文献

活细胞、微管蛋白和微管的近红外光生物调节

Near-Infrared Photobiomodulation of Living Cells, Tubulin, and Microtubules .

作者信息

Staelens Michael, Di Gregorio Elisabetta, Kalra Aarat P, Le Hoa T, Hosseinkhah Nazanin, Karimpoor Mahroo, Lim Lew, Tuszyński Jack A

机构信息

Department of Physics, University of Alberta, Edmonton, AB, Canada.

Department of Mechanical and Aerospace Engineering, Politecnico di Torino, Turin, Italy.

出版信息

Front Med Technol. 2022 May 4;4:871196. doi: 10.3389/fmedt.2022.871196. eCollection 2022.

Abstract

We report the results of experimental investigations involving photobiomodulation (PBM) of living cells, tubulin, and microtubules in buffer solutions exposed to near-infrared (NIR) light emitted from an 810 nm LED with a power density of 25 mW/cm pulsed at a frequency of 10 Hz. In the first group of experiments, we measured changes in the alternating current (AC) ionic conductivity in the 50-100 kHz range of HeLa and U251 cancer cell lines as living cells exposed to PBM for 60 min, and an increased resistance compared to the control cells was observed. In the second group of experiments, we investigated the stability and polymerization of microtubules under exposure to PBM. The protein buffer solution used was a mixture of Britton-Robinson buffer (BRB aka PEM) and microtubule cushion buffer. Exposure of Taxol-stabilized microtubules (~2 μM tubulin) to the LED for 120 min resulted in gradual disassembly of microtubules observed in fluorescence microscopy images. These results were compared to controls where microtubules remained stable. In the third group of experiments, we performed turbidity measurements throughout the tubulin polymerization process to quantify the rate and amount of polymerization for PBM-exposed tubulin vs. unexposed tubulin samples, using tubulin resuspended to final concentrations of ~ 22.7 μM and ~ 45.5 μM in the same buffer solution as before. Compared to the unexposed control samples, absorbance measurement results demonstrated a slower rate and reduced overall amount of polymerization in the less concentrated tubulin samples exposed to PBM for 30 min with the parameters mentioned above. Paradoxically, the opposite effect was observed in the 45.5 μM tubulin samples, demonstrating a remarkable increase in the polymerization rates and total polymer mass achieved after exposure to PBM. These results on the effects of PBM on living cells, tubulin, and microtubules are novel, further validating the modulating effects of PBM and contributing to designing more effective PBM parameters. Finally, potential consequences for the use of PBM in the context of neurodegenerative diseases are discussed.

摘要

我们报告了一系列实验研究的结果,这些研究涉及对缓冲溶液中的活细胞、微管蛋白和微管进行光生物调节(PBM),该缓冲溶液暴露于由功率密度为25 mW/cm²、频率为10 Hz脉冲的810 nm发光二极管(LED)发出的近红外(NIR)光下。在第一组实验中,我们测量了HeLa和U251癌细胞系在50 - 100 kHz范围内的交流(AC)离子电导率变化,这些活细胞暴露于PBM 60分钟,与对照细胞相比,观察到电阻增加。在第二组实验中,我们研究了微管在暴露于PBM时的稳定性和聚合情况。所使用的蛋白质缓冲溶液是布里顿 - 罗宾逊缓冲液(BRB,又名PEM)和微管垫层缓冲液的混合物。将紫杉醇稳定的微管(约2 μM微管蛋白)暴露于LED 120分钟,导致在荧光显微镜图像中观察到微管逐渐解聚。这些结果与微管保持稳定的对照进行了比较。在第三组实验中,我们在整个微管蛋白聚合过程中进行了浊度测量,以量化暴露于PBM的微管蛋白与未暴露的微管蛋白样品的聚合速率和聚合量,微管蛋白在与之前相同的缓冲溶液中重悬至最终浓度约为22.7 μM和45.5 μM。与未暴露的对照样品相比,吸光度测量结果表明,在上述参数下,暴露于PBM 30分钟的浓度较低的微管蛋白样品的聚合速率较慢,且聚合总量减少。矛盾的是,在45.5 μM微管蛋白样品中观察到相反的效果,表明暴露于PBM后聚合速率和总聚合物质量显著增加。这些关于PBM对活细胞、微管蛋白和微管影响的结果是新颖的,进一步验证了PBM的调节作用,并有助于设计更有效的PBM参数。最后,讨论了在神经退行性疾病背景下使用PBM的潜在后果。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/e65c/9115106/3864cecdadf2/fmedt-04-871196-g0001.jpg

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验