Grochowicz Marta, Szajnecki Łukasz, Rogulska Magdalena
Department of Polymer Chemistry, Institute of Chemical Sciences, Faculty of Chemistry, Maria Curie-Sklodowska University, 20-031 Lublin, Poland.
Polymers (Basel). 2022 May 20;14(10):2080. doi: 10.3390/polym14102080.
Nowadays, ibuprofen and ketoprofen are widely used over-the-counter medications to treat inflammation, fever, or pain. Their high consumption and improper disposal cause them to get into the environment and often pollute surface water. In this study, the new polymeric porous microspheres based on 4-vinylpyridine (4VP) are presented as effective sorbents for ibuprofen and ketoprofen preconcentration and removal. The porous microspheres were obtained via seed swelling polymerization with the use of two types of methacrylate crosslinkers, i.e., trimethylolpropane trimethacrylate (TRIM) and 1,4-dimethacryloiloxybenzene (14DMB). Additionally, as a reference sorbent, a copolymer of styrene and divinylbenzene was obtained. Porous structure investigations showed that the microspheres possess a specific surface area of about 100 m/g, but noticeable differences were observed in their internal topography depending on the type of crosslinker used. Moreover, the porous structure of dry and swollen microspheres differs significantly. Swollen copolymers reveal the presence of micropores. The 4VP microspheres are characterized by high thermal stability; their initial decomposition temperature is about 300 °C. The performance of the 4VP copolymers as sorbents in aqueous solutions of drugs was evaluated in static and dynamic modes at three pH values of 3, 7, and 11. The highest sorption efficiency was obtained for ibuprofen and ketoprofen in pH 3. Both 4VP copolymers indicate the high sorption capacity in a static sorption as follows: towards ketoprofen of about 40 mg/g whereas towards ibuprofen of about 90 mg/g and 75 mg/g on copolymer crosslinked with trimethylolpropane trimethacrylate and 1,4-dimethacryloiloxybenzene, respectively. The recovery of ibuprofen and ketoprofen after dynamic sorption experiments was higher than 90%.
如今,布洛芬和酮洛芬是广泛使用的非处方药物,用于治疗炎症、发烧或疼痛。它们的高消费量和不当处置导致其进入环境并经常污染地表水。在本研究中,基于4-乙烯基吡啶(4VP)的新型聚合物多孔微球被提出作为布洛芬和酮洛芬预浓缩和去除的有效吸附剂。通过种子溶胀聚合,使用两种类型的甲基丙烯酸酯交联剂,即三羟甲基丙烷三甲基丙烯酸酯(TRIM)和1,4-二甲基丙烯酰氧基苯(14DMB),获得了多孔微球。此外,作为参考吸附剂,获得了苯乙烯和二乙烯基苯的共聚物。多孔结构研究表明,微球的比表面积约为100 m/g,但根据所用交联剂的类型,其内部形貌存在明显差异。此外,干燥和溶胀微球的多孔结构也有显著差异。溶胀共聚物显示出微孔的存在。4VP微球具有高热稳定性;其初始分解温度约为300°C。在pH值为3、7和11的三种条件下,以静态和动态模式评估了4VP共聚物作为药物水溶液吸附剂的性能。在pH 3时,布洛芬和酮洛芬的吸附效率最高。两种4VP共聚物在静态吸附中均显示出高吸附容量,如下所示:对于酮洛芬约为40 mg/g,而对于布洛芬,在与三羟甲基丙烷三甲基丙烯酸酯和1,4-二甲基丙烯酰氧基苯交联的共聚物上分别约为90 mg/g和75 mg/g。动态吸附实验后,布洛芬和酮洛芬的回收率高于90%。