Zhang Yang, Gai Changcheng, Song Binghui, Jiang Jiguo, Wang Zhiqiang
Karamay Campus, Faculty of Petroleum, China University of Petroleum (Beijing), Karamay, 834000, Xinjiang, China.
Research Institute of Exploration and Development, PetroChina Jidong Oilfield Company, Tangshan, 063004, Hebei, China.
Sci Rep. 2023 Aug 31;13(1):14316. doi: 10.1038/s41598-023-39535-2.
To investigate the impact of permeability and heterogeneity on oil displacement efficiency and remaining oil distribution of chemical flooding, three groups of high and ultrahigh permeability core samples from an ultrahigh water-cut oilfield in western China were selected as the research objects in this study. High-pressure mercury injection, scanning electron microscopy, wettability test, and other methods were used to characterize the reservoir properties of core samples. Six groups of experiments were performed using the nuclear magnetic resonance (NMR) displacement imaging technology to simulate the oilfield development process considering the economic benefits. The displacement stage with the best oil displacement effect in the process of waterflooding, chemical flooding and then waterflooding was defined, and the control effect of permeability and heterogeneity on the improvement of oil displacement efficiency by polymer-surfactant binary flooding was discussed. The distribution position of remaining oil in different displacement stages was quantitatively and visually displayed, and its control factors were revealed. The research shows that during the simulation process of first waterflooding followed by chemical flooding and then waterflooding in the oilfield, the T spectrum signal amplitude increases the most in the two stages, one is from saturated oil flooding to 50% water cut and the other one is from 95% water cut to the end of 1 PV polymer flooding. The oil displacement efficiency increases the most, and the oil is primarily discharged from pore throats larger than 90 ms (or with pore throat radius of 8.37 μm). Compared with heterogeneity, permeability plays a more obvious controlling role in improving the oil displacement efficiency of polymer-surfactant binary flooding. The influence of fingering phenomenon on the distribution of remaining oil is most obvious in the second waterflooding, and the distribution of remaining oil with polymer slug is more obviously affected by the fingering phenomenon than that with polymer-surfactant slug. The study results provide theoretical guidance for tapping the remaining oil potential of old oilfields with high to ultrahigh permeabilities.
为研究渗透率和非均质性对化学驱油驱油效率及剩余油分布的影响,选取了中国西部某特高含水油田的三组高渗和特高渗岩心样品作为本研究的研究对象。采用高压汞注入、扫描电子显微镜、润湿性测试等方法对岩心样品的储层性质进行表征。考虑经济效益,利用核磁共振(NMR)驱替成像技术进行了六组实验以模拟油田开发过程。确定了水驱、化学驱再水驱过程中驱油效果最佳的驱替阶段,探讨了渗透率和非均质性对聚合物 - 表面活性剂二元驱提高驱油效率的控制作用。定量直观地展示了不同驱替阶段剩余油的分布位置,并揭示了其控制因素。研究表明,在油田先水驱、再化学驱然后再水驱的模拟过程中,T谱信号幅度在两个阶段增加最多,一个是从饱和油驱替到含水率50%,另一个是从含水率95%到1PV聚合物驱替结束。驱油效率提高最多,油主要从大于90ms(或孔喉半径为8.37μm)的孔喉中排出。与非均质性相比,渗透率对提高聚合物 - 表面活性剂二元驱的驱油效率起更明显的控制作用。指进现象对剩余油分布的影响在第二次水驱中最为明显,聚合物段塞驱替时剩余油的分布比聚合物 - 表面活性剂段塞驱替时受指进现象的影响更明显。研究结果为挖掘高渗到特高渗老油田的剩余油潜力提供了理论指导。