Wang Yujing, Xia Junwu, Li Pengxu, Yu Linli, Yang Han, Chen Yidong
State Key Laboratory for Geomechanics and Deep Underground Engineering, China University of Mining and Technology, Xuzhou 221116, China.
Jiangsu Collaborative Innovation Center of Building Energy-Saving and Construction Technology, Jiangsu Vocational Institute of Architectural Technology, Xuzhou 221116, China.
Materials (Basel). 2023 Nov 9;16(22):7104. doi: 10.3390/ma16227104.
To assess the freeze-thaw (F-T) durability of coal gangue pervious concrete (CGPC) in different F-T cycle media (water, 3.5 wt% NaCl solution), experimental studies on 36 groups of cube specimens and 6 groups of prismatic specimens were carried out, with designed porosity, F-T cycling media, and F-T failure times as variables. The changes in apparent morphology, mass, compressive behavior, relative dynamic elastic modulus, and permeability coefficient have been analyzed in detail. To predict the compressive strength after F-T cycles, a GM (1,1) model based on the grey system theory was developed and further improved into a more accurate grey residual-Markov model. The results reported that the cement slurry and coal gangue aggregates (CGAs) on the specimen surface continued to fall off as F-T cycles increased, and, finally, the weak point was fractured. Meanwhile, the decrease in compressive behavior and relative dynamic elastic modulus was gentle in the early phase of F-T cycles, and they gradually became faster in the later stage, showing a parabolic downward trend. The permeability coefficient increased gradually. When F-T failure occurred, specimen mass dropped precipitously. The F-T failure of CGPC was more likely to occur in 3.5 wt% NaCl solution, and the F-T failure times of samples were 25 times earlier than that of water. This study lays the foundation for an engineering application and provides a basis for the large-scale utilization of CGPC.
为评估煤矸石透水混凝土(CGPC)在不同冻融(F-T)循环介质(水、3.5 wt% NaCl溶液)中的冻融耐久性,以设计孔隙率、F-T循环介质和F-T破坏次数为变量,对36组立方体试件和6组棱柱体试件进行了试验研究。详细分析了表观形态、质量、抗压性能、相对动弹模量和渗透系数的变化。为预测F-T循环后的抗压强度,基于灰色系统理论建立了GM(1,1)模型,并进一步改进为更精确的灰色残差-马尔可夫模型。结果表明,随着F-T循环次数增加,试件表面的水泥浆体和煤矸石集料(CGAs)不断脱落,最终薄弱点发生断裂。同时,抗压性能和相对动弹模量在F-T循环初期下降平缓,后期逐渐加快,呈抛物线下降趋势。渗透系数逐渐增大。发生F-T破坏时,试件质量急剧下降。CGPC在3.5 wt% NaCl溶液中更容易发生F-T破坏,试件的F-T破坏次数比在水中早25倍。本研究为工程应用奠定了基础,为CGPC的大规模利用提供了依据。