Suppr超能文献

水和 TFA 添加对肽亚/超临界流体分离影响的基础研究。

Fundamental investigation of impact of water and TFA additions in peptide sub/supercritical fluid separations.

机构信息

Department of Engineering and Chemical Sciences, Karlstad University, Karlstad SE-651 88, Sweden.

Department of Engineering and Chemical Sciences, Karlstad University, Karlstad SE-651 88, Sweden.

出版信息

J Chromatogr A. 2024 Sep 13;1732:465203. doi: 10.1016/j.chroma.2024.465203. Epub 2024 Jul 21.

Abstract

The retention of three peptides was studied under analytical and overloaded conditions at different concentrations of trifluoroacetic acid (TFA) and water added to the co-solvent methanol (MeOH). Four columns with different stationary phase properties, i.e., silica, diol, 2-ethylpyridine and cyanopropyl (CN) columns, were evaluated in this investigation. The overall aim was to get a deeper understanding on how column chemistry as well as water and TFA in the co-solvent affect the analytical and overloaded elution profiles using multivariate design of experiments and adsorption measurements of co-solvent components. Multivariate experimental design modeling indicated that water had on average around five times higher effect on the retention than the addition of TFA. The results also showed that the retention increases with the addition of TFA and water to the co-solvent on all columns except the CN column, on which the retention decreased. When examining the effect of adding water to the co-solvent, evidence of a hydrophilic interaction liquid chromatography (HILIC)-like retention mechanism was found on the three other columns with more polar stationary phases. However, on the CN column water acted as an additive, decreasing the retention due to competition with the peptide for available adsorption surface. Adsorption isotherm measurements of the polar solvent MeOH showed that MeOH adsorbs much weaker on the CN column than on the other columns. Addition of TFA and water to the co-solvent substantially sharpened the elution profiles under both overloaded and analytical conditions. Adding a small amount of TFA (from 0 % to 0.05 %) to the co-solvent substantially improved the peak shape of the elution profiles, while further addition (from 0.05 % to 0.15 %) had only a minor effect on the elution profile shape. The reduced retention on the CN column could not be explained by TFA adsorption, which was very weak on all studied columns (retention factor, 0.05-0.15). One could therefore speculate that the ion-pairing complex formed between the peptide and TFA in the mobile phase, reduce the retention due to its reduced polarity. On the other columns displaying HILIC-like properties, the TFA probably just decreased the pH of the mobile phase, thereby promoting the partitioning of the peptide into the water-rich layer. Finally, peak deformation due to diluent-eluent mismatch was observed under overloaded conditions. This was most severe in the cases where MeOH adsorption to the stationary phase was strong and the peptides were only mildly retained. Adding 1,4-dioxan to the diluent resolved this issue.

摘要

研究了在不同浓度三氟乙酸(TFA)和添加到共溶剂甲醇(MeOH)中的水的情况下,在分析和过载条件下保留三种肽。评估了四种具有不同固定相性质的柱子,即硅胶、二醇、2-乙基吡啶和氰丙基(CN)柱。本研究的总体目标是更深入地了解柱化学以及共溶剂中的水和 TFA 如何影响使用多元实验设计和共溶剂成分吸附测量的分析和过载洗脱曲线。多元实验设计建模表明,水对保留的影响平均比添加 TFA 高约五倍。结果还表明,除了 CN 柱外,所有柱子的共溶剂中添加 TFA 和水都会导致保留增加,而在 CN 柱上,保留减少。当研究向共溶剂中添加水的影响时,在其他三个具有更极性固定相的柱子上发现了亲水相互作用液相色谱(HILIC)样保留机制的证据。然而,在 CN 柱上,水充当添加剂,由于与肽竞争可用的吸附表面,保留减少。对极性溶剂 MeOH 的吸附等温线测量表明,MeOH 在 CN 柱上的吸附比在其他柱子上弱得多。在过载和分析条件下,共溶剂中添加 TFA 和水都大大改善了洗脱曲线的锐度。向共溶剂中添加少量 TFA(从 0%到 0.05%)可大大改善洗脱曲线的峰形,而进一步添加(从 0.05%到 0.15%)对洗脱曲线形状只有很小的影响。在 CN 柱上保留的减少不能用 TFA 吸附来解释,因为 TFA 在所有研究的柱子上都非常弱(保留因子为 0.05-0.15)。因此,可以推测在流动相中形成的肽与 TFA 的离子对复合物由于其极性降低而减少保留。在显示出 HILIC 样性质的其他柱子上,TFA 可能只是降低了流动相的 pH 值,从而促进了肽分配到富含水的层中。最后,在过载条件下观察到由于稀释剂-洗脱剂不匹配导致的峰变形。在 MeOH 对固定相吸附强且肽保留轻微的情况下,情况最为严重。向稀释剂中添加 1,4-二恶烷可以解决此问题。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验