Darby N J, Creighton T E
MRC Laboratory of Molecular Biology, Cambridge, UK.
J Mol Biol. 1993 Aug 5;232(3):873-96. doi: 10.1006/jmbi.1993.1437.
The kinetics of disulphide bond formation and breakage have been measured in five analogues of the single-disulphide intermediates that occur in folding of bovine pancreatic trypsin inhibitor (BPTI), in which the cysteine residues not involved in disulphide bonds have been replaced by serine residues. Only a single disulphide bond can be made in each analogue, allowing the rates and equilibrium constants of the corresponding microscopic steps to be determined. These steps cannot be characterized in normal BPTI with six cysteine residues, as only the total overall rate of forming all 15 possible disulphide bonds can be measured. The intramolecular rate of forming each disulphide bond was found in the dithiol forms of reduced BPTI to be approximately proportional inversely to the size of the disulphide loop formed. On this basis, the 30-51 disulphide bond is not formed preferentially in the fully reduced protein, even though it predominates amongst the one-disulphide intermediates as a result of rapid intramolecular disulphide rearrangements. It is found to be more stable than the other one-disulphide intermediates because its disulphide is more stable to reduction than the others. This is undoubtedly due to the stable partially folded structure of (30-51), as the other intermediates are much less structured under folding conditions. Urea (8 M) uniformly decreased by a factor of 5 the effective concentrations of cysteine thiol groups in the analogues and in reduced BPTI, suggesting that reduced BPTI under normal refolding conditions is not an ideal random coil; any non-random conformations do not, however, favour formation of any specific disulphide bonds. Findings from these studies have led to further refinement and development of various approaches to measuring and interpreting the intramolecular rates of disulphide bond formation and breakage in proteins.
在牛胰蛋白酶抑制剂(BPTI)折叠过程中出现的单二硫键中间体的五种类似物中,已测量了二硫键形成和断裂的动力学。在这些类似物中,未参与二硫键形成的半胱氨酸残基已被丝氨酸残基取代。每个类似物中只能形成一个二硫键,从而可以确定相应微观步骤的速率和平衡常数。在具有六个半胱氨酸残基的正常BPTI中无法表征这些步骤,因为只能测量形成所有15种可能二硫键的总总体速率。在还原型BPTI的二硫醇形式中发现,形成每个二硫键的分子内速率大约与所形成二硫键环的大小成反比。在此基础上,即使在完全还原的蛋白质中,30-51二硫键也不是优先形成的,尽管由于分子内二硫键的快速重排,它在单二硫键中间体中占主导地位。发现它比其他单二硫键中间体更稳定,因为其对还原的稳定性比其他中间体更高。这无疑是由于(30-51)具有稳定的部分折叠结构,因为其他中间体在折叠条件下的结构要少得多。8M尿素使类似物和还原型BPTI中半胱氨酸硫醇基团的有效浓度均匀降低了5倍,这表明在正常重折叠条件下还原型BPTI不是理想的无规卷曲;然而,任何非无规构象都不会有利于任何特定二硫键的形成。这些研究结果导致了各种测量和解释蛋白质中二硫键形成和断裂分子内速率的方法得到进一步完善和发展。