Berg H C, Turner L
Rowland Institute for Science, Harvard University, Cambridge, Massachusetts 02138-2020.
Biophys J. 1993 Nov;65(5):2201-16. doi: 10.1016/S0006-3495(93)81278-5.
Cells of the bacterium Escherichia coli were tethered and spun in a high-frequency rotating electric field at a series of discrete field strengths. This was done first at low field strengths, then at field strengths generating speeds high enough to disrupt motor function, and finally at low field strengths. Comparison of the initial and final speed versus applied-torque plots yielded relative motor torque. For backward rotation, motor torque rose steeply at speeds close to zero, peaking, on average, at about 2.2 times the stall torque. For forward rotation, motor torque remained approximately constant up to speeds of about 60% of the zero-torque speed. Then the torque dropped linearly with speed, crossed zero, and reached a minimum, on average, at about -1.7 times the stall torque. The zero-torque speed increased with temperature (about 90 Hz at 11 degrees C, 140 Hz at 16 degrees C, and 290 Hz at 23 degrees C), while other parameters remained approximately constant. Sometimes the motor slipped at either extreme (delivered constant torque over a range of speeds), but eventually it broke. Similar results were obtained whether motors broke catastrophically (suddenly and completely) or progressively or were de-energized by brief treatment with an uncoupler. These results are consistent with a tightly coupled ratchet mechanism, provided that elastic deformation of force-generating elements is limited by a stop and that mechanical components yield at high applied torques.
将大肠杆菌细胞固定,并在一系列离散场强的高频旋转电场中旋转。首先在低场强下进行,然后在产生足以破坏电机功能的高速度的场强下进行,最后在低场强下进行。比较初始和最终速度与施加扭矩的曲线,得出相对电机扭矩。对于反向旋转,电机扭矩在接近零的速度时急剧上升,平均在约2.2倍失速扭矩时达到峰值。对于正向旋转,电机扭矩在达到约零扭矩速度的60%之前大致保持恒定。然后扭矩随速度线性下降,越过零,并平均在约-1.7倍失速扭矩时达到最小值。零扭矩速度随温度升高(11摄氏度时约为90赫兹,16摄氏度时为140赫兹,23摄氏度时为290赫兹),而其他参数大致保持恒定。有时电机在任一极端情况下会打滑(在一定速度范围内提供恒定扭矩),但最终会损坏。无论电机是灾难性地(突然且完全地)、渐进地损坏,还是通过用解偶联剂短暂处理使其断电,都能得到类似的结果。这些结果与紧密耦合的棘轮机制一致,前提是力产生元件的弹性变形受到限位器限制,并且机械部件在高施加扭矩下会屈服。