Leimkuhler M, Goldbeck A, Lechner M D, Witz J
Physikalische Chemie, Institut fur Chemie, Universitat Osnabruck, Osnabruck, 49069, Germany.
J Mol Biol. 2000 Mar 10;296(5):1295-305. doi: 10.1006/jmbi.2000.3538.
The stability of bromegrass mosaic virus (BMV) and empty shells reassembled in vitro from purified BMV coat protein was investigated under hydrostatic pressure, using solution small-angle neutron scattering. This technique allowed us to monitor directly the dissociation of the particles, and to detect conformational changes preceding dissociation. Significant dissociation rates were observed only if virions swelled upon increase of pressure, and pressure effects became irreversible at very high-pressure in such conditions. At pH 5.0, in buffers containing 0.5 M NaCl and 5 mM MgCl(2), BMV remained compact (radius 12.9 nm), dissociation was limited to approximately 10 % at 200 MPa, and pressure effects were totally reversible. At pH 5.9, BMV particles were slightly swollen under normal pressure and swelling increased with pressure. The dissociation was reversible to 90 % for pressures up to 160 MPa, where its rate reached 28 %, but became totally irreversible at 200 MPa. Pressure-induced swelling and dissociation increased further at pH 7.3, but were essentially irreversible. The presence of (2)H(2)O in the buffer strongly stabilized BMV against pressure effects at pH 5.9, but not at pH 7.3. Furthermore, the reversible changes of the scattered intensity observed at pH 5.0 and 5.9 provide evidence that pressure could induce the release of coat protein subunits, or small aggregates of these subunits from the virions, and that the dissociated components reassociated again upon return to low pressure. Empty shells were stable at pH 5.0, at pressures up to 260 MPa. They became ill-shaped at high-pressure, however, and precipitated slowly after return to normal conditions, providing the first example of a pressure-induced conformational drift in an assembled system.
利用溶液小角中子散射技术,研究了雀麦花叶病毒(BMV)以及由纯化的BMV外壳蛋白在体外重新组装而成的空壳在静水压力下的稳定性。该技术使我们能够直接监测颗粒的解离,并检测解离前的构象变化。只有当病毒粒子在压力增加时膨胀,才会观察到显著的解离速率,并且在这种情况下,在非常高的压力下压力效应变得不可逆。在pH 5.0时,在含有0.5 M NaCl和5 mM MgCl₂的缓冲液中,BMV保持紧密(半径12.9 nm),在200 MPa下解离限制在约10%,并且压力效应完全可逆。在pH 5.9时,BMV颗粒在常压下略有膨胀,且膨胀随压力增加。在高达160 MPa的压力下,解离可逆至90%,此时解离速率达到28%,但在200 MPa时变得完全不可逆。在pH 7.3时,压力诱导的膨胀和解离进一步增加,但基本上是不可逆的。缓冲液中重水的存在在pH 5.9时强烈稳定BMV抵抗压力效应,但在pH 7.3时则不然。此外,在pH 5.0和5.9时观察到的散射强度的可逆变化提供了证据,表明压力可诱导外壳蛋白亚基或这些亚基的小聚集体从病毒粒子中释放,并且解离的组分在恢复到低压时会再次重新结合。空壳在pH 5.0、高达260 MPa的压力下是稳定的。然而,它们在高压下会变形,并且在恢复到正常条件后会缓慢沉淀,这为组装系统中压力诱导的构象漂移提供了第一个例子。