Sanderson W T, Steenland K, Deddens J A
Industrywide Studies Branch, Division of Surveillance, Hazard Evaluations, and Field Studies, National Institute for Occupational Safety and Health, 4676 Columbia Parkway, Cincinnati, Ohio 45226-1998, USA.
Am J Ind Med. 2000 Oct;38(4):389-98. doi: 10.1002/1097-0274(200010)38:4<389::aid-ajim4>3.0.co;2-j.
Besides a clear relationship to silicosis, crystalline silica-quartz-has been associated with lung cancer, nonmalignant renal disease, and auto-immune disease. To study diseases associated with crystalline silica further, NIOSH conducted a cohort mortality study of workers from 18 silica sand plants, which had quarry, crushing, and bagging operations to produce industrial sand. Twelve of these plants also had grinding mills to produce fine silica powder. The historical crystalline silica exposures of workers at these plants were estimated to facilitate exposure-response analyses in the epidemiologic study.
NIOSH obtained personal respirable dust measurement records from Mine Safety and Health Administration (MSHA) compliance inspections at all 18 plants and from the archives of seven plants which had collected samples. These samples had been analyzed for quartz content by x-ray diffraction. Although no personal samples were available before 1974, impinger dust measurements were reported for 19 silica sand plants in 1946; these data were converted and used to estimate exposures prior to 1974. Statistical modeling of the samples was used to estimate quartz exposure concentrations for workers in plant-job-year categories from the 1930s when mortality follow-up of the cohort began until 1988 when follow-up stopped.
Between 1974 and 1996, there were 4,269 respirable dust samples collected at these 18 plants. The geometric mean quartz concentration was 25.9 microg/m(3) (GSD = 10.9) with a range from less than 1 to 11,700 microg/m(3). Samples below 1 microg/m(3) were given a value of 0.5 microg/m(3). Over one-third of the samples -37%) exceeded the MSHA permissible exposure limit value for quartz (PEL = 10 mg/m(3)/(%quartz + 2)) and half (51%) of the samples exceeded the NIOSH recommended exposure limit (REL=50 microg/m(3)). The samples were collected from workers performing 143 jobs within the 18 plants, but too few samples were collected from many of the jobs to make accurate estimates. Therefore, samples were combined into 10 categories of jobs performing similar tasks or located within the same plant area.
The quartz concentrations varied significantly by plant, job, and year. Quartz concentrations decreased over time, with measurements collected in the 1970s significantly greater than those collected later. The modeled exposure estimates improve upon duration of employment as an estimate of cumulative exposure and reduce exposure misclassification due to variation in quartz levels between plants, jobs, and over time. Am. J. Ind. Med. 38:389-398, 2000. Published 2000 Wiley-Liss, Inc.
除了与矽肺有明确关联外,结晶二氧化硅(石英)还与肺癌、非恶性肾病及自身免疫性疾病有关。为进一步研究与结晶二氧化硅相关的疾病,美国国家职业安全与健康研究所(NIOSH)对来自18家硅砂厂的工人进行了队列死亡率研究,这些工厂有采石、破碎和装袋作业以生产工业用砂。其中12家工厂还有研磨机来生产精细硅粉。估算了这些工厂工人过去接触结晶二氧化硅的情况,以便在流行病学研究中进行暴露-反应分析。
NIOSH从美国矿山安全与健康管理局(MSHA)对所有18家工厂的合规检查记录以及7家曾采集样本的工厂档案中获取了个人可吸入粉尘测量记录。这些样本通过X射线衍射分析了石英含量。尽管1974年之前没有个人样本,但报告了1946年19家硅砂厂的冲击式粉尘测量数据;这些数据经过转换后用于估算1974年之前的暴露情况。对样本进行统计建模,以估算从队列死亡率随访开始的20世纪30年代到随访结束的1988年期间,按工厂-工作-年份类别划分的工人石英暴露浓度。
1974年至1996年期间,在这18家工厂共采集了4269份可吸入粉尘样本。石英浓度的几何平均值为25.9微克/立方米(几何标准差=10.9),范围从小于1微克/立方米到11700微克/立方米。低于1微克/立方米的样本取值为0.5微克/立方米。超过三分之一(37%)的样本超过了MSHA规定的石英允许暴露限值(PEL = 10毫克/立方米/(石英百分比+2)),一半(51%)的样本超过了NIOSH推荐的暴露限值(REL = 50微克/立方米)。样本是从18家工厂内从事143种工作的工人中采集的,但许多工作采集的样本太少,无法进行准确估算。因此,将样本合并为10类从事类似任务或位于同一厂区的工作。
石英浓度因工厂、工作和年份而异。石英浓度随时间下降,20世纪70年代采集的测量值明显高于后期。建模的暴露估算在作为累积暴露估算的就业时长方面有所改进,并减少了因工厂、工作和时间不同导致的石英水平差异造成的暴露误分类。《美国工业医学杂志》38:389 - 398,2000年。2000年由威利 - 利斯公司出版。