Naimushin A N, Quach N, Fujimoto B S, Schurr J M
Department of Chemistry, Campus Box 351700, University of Washington, Seattle, Washington 98195-1700, USA.
Biopolymers. 2001 Feb;58(2):204-17. doi: 10.1002/1097-0282(200102)58:2<204::AID-BIP90>3.0.CO;2-1.
The supercoiling free energy of pUC19 DNA [2686 base pairs (bp)] was measured in various concentrations of PEG 8000 (polyethylene glycol; molecular weight 8000) by the topoisomer distribution method. The effective twist energy parameter (E(T)) that governs the supercoiling free energy declined linearly by 1.9-fold with increasing w/v % PEG from 0 to 7.5%, which lies below the threshold for intermolecular condensation. In principle, PEG could affect E(T) either via an osmotic exclusion mechanism or by altering the torsion elastic constant, bending rigidity, or self-repulsions of the DNA. Possible alterations of the DNA secondary structure and torsion elastic constant were assessed by CD spectroscopy and time-resolved fluorescence polarization anisotropy of intercalated ethidium. Up to 7.5% PEG, the secondary structure of the DNA remained largely unaltered, as evidenced by (1) the absence of any significant change in the CD spectrum, (2) an extremely small relative decrease (-0.0013) in intrinsic twist, and (3) a negligibly small change in the torsion elastic constant. The observed reduction in E(T) cannot be ascribed primarily to a decrease in torsion elastic constant, and most likely does not stem from a decrease in bending rigidity either. The decrease in medium dielectric constant due to PEG should increase the self-repulsions, and thereby increase E(T), which is opposite to the observed trend. Instead, the observed decline in E(T) is attributed to an osmotic exclusion mechanism. The change in molar volume excluded to the PEG (Delta V(ex)), when the linking difference converts from Delta l = 0 to Delta l = +/-1, was determined from the observed E(T) value and PEG osmotic pressure at each concentration. The experimental Delta V(ex) values agree well with theoretical estimates reckoned for a simple osmotic exclusion model, in which PEG is excluded by hard-core interactions from a concentric cylindrical volume around every duplex segment. The difference in volume excluded to PEG between the Delta l = 0 and the Delta l = +/-1 topoisomers is attributed entirely to the approximately 0.7 additional writhe "crossing" of two duplex strands at roughly 90 degrees, which is known to occur in the latter species. When the separation between the duplex centers at the "crossing" was adjusted so that the theoretical estimate of Delta V(ex) matched the experimental value at each PEG concentration, a value near 5.7 nm was obtained in each case. The invariance and plausible magnitude of this mean separation at the crossing provide strong support for this simple osmotic exclusion model. An alternative model, in which the PEG is excluded from the entire coil envelope of the DNA out to its radius of gyration, perhaps because it decreases the local dielectric constant, was also considered. The estimated difference in excluded volume in that case exceeds the experimental value by a factor of nearly 10(4), and could be ruled out on that basis.
通过拓扑异构体分布方法,在不同浓度的聚乙二醇8000(PEG 8000;分子量8000)中测量了pUC19 DNA(2686个碱基对)的超螺旋自由能。控制超螺旋自由能的有效扭曲能参数(E(T))随着PEG的重量/体积百分比从0增加到7.5%而线性下降了1.9倍,该浓度低于分子间凝聚的阈值。原则上,PEG可能通过渗透排斥机制或通过改变DNA的扭转弹性常数、弯曲刚度或自身排斥力来影响E(T)。通过圆二色光谱(CD)和嵌入溴化乙锭的时间分辨荧光偏振各向异性评估了DNA二级结构和扭转弹性常数的可能变化。高达7.5%的PEG时,DNA的二级结构基本保持不变,这表现为:(1)CD光谱没有任何显著变化;(2)内在扭曲的相对减少极小(-0.0013);(3)扭转弹性常数的变化可忽略不计。观察到的E(T)降低不能主要归因于扭转弹性常数的降低,很可能也不是源于弯曲刚度的降低。由于PEG导致的介质介电常数降低应该会增加自身排斥力,从而增加E(T),这与观察到的趋势相反。相反,观察到的E(T)下降归因于渗透排斥机制。当连接差从Δl = 0转换为Δl = +/-1时,从每个浓度下观察到的E(T)值和PEG渗透压确定了被PEG排除的摩尔体积变化(ΔV(ex))。实验得到的ΔV(ex)值与简单渗透排斥模型的理论估计值非常吻合,在该模型中,PEG通过硬核相互作用从每个双链片段周围的同心圆柱体积中被排除。Δl = 0和Δl = +/-1拓扑异构体之间被PEG排除的体积差异完全归因于两条双链在大约90度处大约0.7个额外的扭曲“交叉”,这在后者中是已知会发生的。当调整“交叉”处双链中心之间的间距,使得ΔV(ex)的理论估计值与每个PEG浓度下的实验值匹配时,每种情况下都得到了接近5.7 nm的值。交叉处这种平均间距的不变性和合理大小为这个简单的渗透排斥模型提供了有力支持。还考虑了另一种模型,即PEG从DNA的整个螺旋包络直至其回转半径都被排除,这可能是因为它降低了局部介电常数。在那种情况下估计的排除体积差异比实验值超出了近10^4倍,因此可以基于此排除该模型。