Sitler David F, Amendola Annunziato, Bailey Christopher S, Thain Lisa M F, Spouge Alison
Fowler Kennedy Sport Medicine Clinic, Univeristy of Western Ontario, London, Canada.
J Bone Joint Surg Am. 2002 May;84(5):763-9.
Ankle arthroscopy has generally been performed with use of anterior portals with the patient in the supine position. Little has been published on ankle arthroscopy performed with use of posterior portals, particularly with the patient in the prone position. The purpose of the present study was to evaluate the relative safety and efficacy of ankle arthroscopy with use of posterior portals with the limb in the prone position.
Thirteen fresh-frozen cadaver specimens were used. Posterolateral and posteromedial portals were established. Arthroscopy was performed, and the extent of the talar dome that could be visualized was marked. Four-millimeter plastic cannulae were filled with oil and were placed in the portals for use as reference landmarks on magnetic resonance imaging studies. The proximity of the portal cannulae to the adjacent structures was measured on standard magnetic resonance images and then during careful dissection. The distances measured by dissection were compared with the measurements made on magnetic resonance images.
An average of 54% (range, 42% to 73%) of the talar dome could be visualized. The average distance between a cannula and adjacent anatomic structures after dissection was 3.2 mm (range, 0 to 8.9 mm) to the sural nerve, 4.8 mm (range, 0 to 11.0 mm) to the small saphenous vein, 6.4 mm (range, 0 to 16.2 mm) to the tibial nerve, 9.6 mm (range, 2.4 to 20.1 mm) to the posterior tibial artery, 17 mm (range, 19 to 31 mm) to the medial calcaneal nerve, and 2.7 mm (range, 0 to 11.2 mm) to the flexor hallucis longus tendon. The magnetic resonance images demonstrated very similar distances except in the case of the distance between the posteromedial cannula and the tibial nerve, which often was difficult to specifically identify on magnetic resonance imaging studies.
The findings of the present cadaveric study suggest that, with the patient in the prone position, arthroscopic equipment may be introduced into the posterior aspect of the ankle without gross injury to the posterior neurovascular structures. Limited clinical trials should be carried out to confirm this finding.
踝关节镜检查通常是在患者仰卧位时通过前侧入路进行。关于采用后侧入路进行踝关节镜检查的报道较少,尤其是患者俯卧位时。本研究的目的是评估在肢体俯卧位时采用后侧入路进行踝关节镜检查的相对安全性和有效性。
使用13个新鲜冷冻尸体标本。建立后外侧和后内侧入路。进行关节镜检查,并标记可观察到的距骨穹窿范围。将4毫米的塑料套管装满油,置于入路中,用作磁共振成像研究的参考标志。在标准磁共振图像上,然后在仔细解剖过程中,测量入路套管与相邻结构的距离。将解剖测量的距离与磁共振图像上的测量值进行比较。
平均可观察到距骨穹窿的54%(范围为42%至73%)。解剖后,套管与相邻解剖结构之间的平均距离分别为:腓肠神经3.2毫米(范围为0至8.9毫米),小隐静脉4.8毫米(范围为0至11.0毫米),胫神经6.4毫米(范围为0至16.2毫米),胫后动脉9.6毫米(范围为2.4至20.1毫米),内侧跟骨神经17毫米(范围为19至31毫米),拇长屈肌腱2.7毫米(范围为0至11.2毫米)。磁共振图像显示的距离非常相似,只是后内侧套管与胫神经之间的距离除外,在磁共振成像研究中该距离通常难以明确识别。
本尸体研究结果表明,在患者俯卧位时,关节镜设备可引入踝关节后方,而不会对后方神经血管结构造成严重损伤。应进行有限的临床试验以证实这一发现。