Suppr超能文献

大鼠精子的鞭毛摆动是由两种功能不同的动力蛋白桥群体与稳定的中央轴丝间隔相互作用所组织的。

The flagellar beat of rat sperm is organized by the interaction of two functionally distinct populations of dynein bridges with a stable central axonemal partition.

作者信息

Lindemann C B, Orlando A, Kanous K S

机构信息

Department of Biological Science, Oakland University, Rochester, MI 48309-4401.

出版信息

J Cell Sci. 1992 Jun;102 ( Pt 2):249-60. doi: 10.1242/jcs.102.2.249.

Abstract

Two distinct patterns of microtubular sliding were observed in rat sperm flagellar axonemes. The particular pattern of sliding was determined by the extraction conditions used to prepare the sperm for axoneme disintegration. Sperm prepared by incubating concentrated suspensions of Triton X-100-extracted sperm at pH 9.0 disintegrated by extruding the doublets and outer dense fibers numbered 4 through 7 in response to Mg-ATP. Sperm prepared by incubating motile Triton X-100-extracted models at 37 degrees C for 1 to 3 hours extruded doublets and outer dense fibers 9, 1 and 2. Axonemes disintegrated by both regimens tended to have doublets 3 and 8 (with their corresponding outer dense fibers), as well as the central pair, in place. In numerous instances, the 3-central-8 complex with outer dense fibers 3 and 8 could be found isolated in midpiece sections prepared from both methods. The 3-central-8 partition was also sometimes seen in isolation in cross-sections of the principal piece where it remained attached to the fibrous sheath. The flagellar remnant produced by extrusion of fibers 4 through 7 under high pH conditions was generally straight or randomly curved. In contrast, the flagellar remnant produced by extrusion of the 9-1-2 bundle of fibers was most often curved into a hook in the midpiece region. While the hook-like configuration was not Ca(2+)-dependent, it may be based on a related mechanism. The sliding of the 9-1-2 group of fibers is a consequence of dynein-tubulin sliding between the 2 and 3 doublets. This sliding pattern appears to be preferentially activated in the motile sperm models in EGTA, but seldom if ever produced sliding in the high-pH-extracted models. We conclude that the 3-central pair-8 complex and associated outer dense fibers form an I-beam-like partition that does not participate in sliding, but acts as a structural foundation for organizing a planar beat. In addition, it is clear that preferential activation of certain dynein arms can be evoked, depending on the treatment regimen employed. This shows definitively that the types of microtubule sliding in the two bend directions are not identical.

摘要

在大鼠精子鞭毛轴丝中观察到两种不同的微管滑动模式。滑动的特定模式取决于用于制备精子以使其轴丝解体的提取条件。通过在pH 9.0下孵育经Triton X-100提取的精子浓缩悬浮液制备的精子,在Mg-ATP作用下,通过挤出双联微管和编号为4至7的外致密纤维而解体。通过将活动的经Triton X-100提取的模型在37℃下孵育1至3小时制备的精子,挤出双联微管和外致密纤维9、1和2。两种方案使轴丝解体后,往往都有双联微管3和8(及其相应的外致密纤维)以及中央微管对保持原位。在许多情况下,由两种方法制备的中段切片中都能发现带有外致密纤维3和8的3-中央-8复合体单独存在。在主段的横切面中有时也能单独看到3-中央-8分区,它仍附着在纤维鞘上。在高pH条件下通过挤出纤维4至7产生的鞭毛残余物通常是直的或随机弯曲的。相比之下,通过挤出9-1-2纤维束产生的鞭毛残余物在中段区域最常弯曲成钩状。虽然钩状结构不依赖于Ca(2+),但它可能基于一种相关机制。9-1-2组纤维的滑动是动力蛋白-微管蛋白在双联微管2和3之间滑动的结果。这种滑动模式似乎在EGTA处理的活动精子模型中优先被激活,但在高pH提取的模型中很少产生滑动,如果有的话。我们得出结论,3-中央微管对-8复合体及相关的外致密纤维形成了一个类似工字梁的分区,它不参与滑动,而是作为组织平面摆动的结构基础。此外,很明显,根据所采用的处理方案,可以诱发某些动力蛋白臂的优先激活。这明确表明,在两个弯曲方向上微管滑动的类型是不同的。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验