Bono Christopher M, Sirkin Michael, Sabatino Christopher T, Reilly Mark C, Tarkin Ivan, Behrens Fred F
Department of Orthopaedic Surgery, Boston Medical Center, Boston, University, Boston, Massachusetts 02118, USA.
J Orthop Trauma. 2003 Nov-Dec;17(10):677-82. doi: 10.1097/00005131-200311000-00003.
To determine the proximity of anteroposterior locking bolts inserted into the distal metaphyseal tibia to nearby neural, vascular, and tendinous structures.
A cadaver study.
University trauma center.
Sixteen legs (8 matched pairs) were nailed in either neutral (Group 1) or 10 degrees of internal rotation (Group 2) and locked using one anteroposterior bolt. The anterior tibial and extensor hallucis longus tendons and neurovascular bundle were identified, and their respective locations in relation to the bolt head were measured. Average distances were calculated for each structure in each group and statistically compared. Damage to any structure was noted at final dissection.
Average distances from the bolt head to the neurovascular bundle, extensor hallucis longus, and anterior tibial tendons were 0.6, 0.5, and 1.6 mm, respectively, for Group 1 and 1.0, 1.5, and 1.8 mm, respectively, for Group 2 legs. Statistical comparison of distances for each anatomic entity for the two groups revealed no detectable significant differences (P = 0.7, 0.4, 0.7, respectively). For all specimens, the rate of nerve, artery, extensor hallucis longus, and anterior tibial tendon injury was 25%, 19%, 0%, and 6%, respectively. However, the incidence of at least one structure damage in Group 1 legs was 63% versus 12% in Group 2 specimens (P = 0.2).
Anteroposterior distal tibial locking bolts lie in close proximity to the neurovascular bundle. With standard percutaneous techniques, these structures can be damaged. Although 10 degrees of internal rotation does not statistically affect the measured distance of the locking bolt to the neurovascular bundle, it appears to decrease the incidence of neurovascular injury. This difference may best be explained by the necessary path the drill bit must take through the soft tissues to reach the underlying bone. Regardless of nail orientation, larger incisions with careful dissection and clear visualization of the anatomy are recommended to help prevent this complication.
确定插入胫骨干骺端远端的前后位锁定螺栓与附近神经、血管和肌腱结构的接近程度。
尸体研究。
大学创伤中心。
16条腿(8对匹配)被固定于中立位(第1组)或内旋10度(第2组),并使用一枚前后位螺栓锁定。识别胫前肌腱、拇长伸肌腱和神经血管束,并测量它们相对于螺栓头部的各自位置。计算每组中每个结构的平均距离并进行统计学比较。在最终解剖时记录对任何结构的损伤情况。
第1组腿从螺栓头部到神经血管束、拇长伸肌腱和胫前肌腱的平均距离分别为0.6毫米、0.5毫米和1.6毫米,第2组腿分别为1.0毫米、1.5毫米和1.8毫米。两组中每个解剖实体距离的统计学比较显示无明显差异(P值分别为0.7、0.4、0.7)。对于所有标本,神经、动脉、拇长伸肌腱和胫前肌腱损伤率分别为25%、19%、0%和6%。然而,第1组腿中至少有一个结构损伤的发生率为63%,而第2组标本为12%(P = 0.2)。
胫骨干骺端远端前后位锁定螺栓与神经血管束距离很近。采用标准经皮技术时,这些结构可能会受损。虽然10度内旋在统计学上不影响锁定螺栓到神经血管束的测量距离,但似乎能降低神经血管损伤的发生率。这种差异最好用钻头到达下方骨骼必须穿过软组织的必要路径来解释。无论髓内钉方向如何,建议采用较大切口并仔细解剖、清晰观察解剖结构,以帮助预防这种并发症。