Kleineidam Sybille, Rügner Hermann, Grathwohl Peter
Geological Institute, Applied Geology Group, University of Tübingen, Sigwartstrasse 10, 72076 Tübingen, Germany.
Environ Sci Technol. 2004 Aug 1;38(15):4169-75. doi: 10.1021/es034846p.
Desorption experiments were carried out in flow through columns following long-term sorption batch experiments (up to 1010 days at 20 degrees C; Rügner, H.; Kleineidam, S.; Grathwohl, P. Long-term sorption kinetics of phenanthrene in aquifer materials. Environ. Sci. Technol. 1999, 33, 1645-1651) to elucidate sorption/desorption hysteresis phenomena of phenanthrene in aquifer materials. Most of the sorbents employed in this study (homogeneous lithocomponents separated from aquifer sediments or fresh rock fragments) showed highly nonlinear sorption isotherms because of coal particles embedded inside the grains. Because sorption capacities were high, sorption equilibrium was not reached in most of the sorbents during the initial sorptive uptake experiments lasting up to 1010 days. Desorption was studied up to 90 days at 20 degrees C. The temperature was raised after that stepwise from originally 20 to 30, 40, 50, and finally to 70 degrees C for selected samples to estimate activation energies of desorption. A numerical intraparticle pore diffusion model was used to fit sorptive uptake data and subsequently for pure forward prediction of the release rates in the desorption column experiments. Desorption was initially fast followed by extended tailing which in other studies is fitted by using multirate first-order models. Our results demonstrate that the retarded intraparticle pore diffusion model can predict the desorption rates with a single diffusion rate constant obtained independently from the long-term batch sorption experiment. No evidence for hysteresis was found, suggesting that many hysteresis phenomena reported earlier are experimental artifacts resulting from nonequilibrium effects and "nonphysical" models. The different temperature steps allowed one to additionally calculate activation energies of desorption (45-59 kJ mol(-1)), which were in reasonably good agreement with results from earlier studies for a retarded pore diffusion process. In addition, equilibrium sorption isotherms were determined at 20 and 40 degrees C to compare sorption and desorption enthalpies. Both were in good agreement, confirming that desorption was not significantly different from sorption.
在长期吸附批量实验(20℃下长达1010天;吕格纳,H.;克莱内伊丹姆,S.;格拉特沃尔,P.菲在含水层材料中的长期吸附动力学。环境科学与技术,1999年,33卷,1645 - 1651页)之后,通过流动柱进行解吸实验,以阐明菲在含水层材料中的吸附/解吸滞后现象。本研究中使用的大多数吸附剂(从含水层沉积物或新鲜岩石碎片中分离出的均匀岩石成分)由于颗粒内部嵌入煤颗粒而呈现高度非线性吸附等温线。由于吸附容量高,在长达1010天的初始吸附摄取实验期间,大多数吸附剂未达到吸附平衡。在20℃下对解吸进行了长达90天的研究。此后,对于选定的样品,温度从最初的20℃逐步升至30℃、40℃、50℃,最后升至70℃,以估计解吸活化能。使用数值颗粒内孔隙扩散模型来拟合吸附摄取数据,并随后用于解吸柱实验中释放速率的纯正向预测。解吸最初很快,随后是长时间的拖尾,在其他研究中使用多速率一级模型进行拟合。我们的结果表明,延迟颗粒内孔隙扩散模型可以用从长期批量吸附实验中独立获得的单个扩散速率常数来预测解吸速率。未发现滞后的证据,这表明早期报道的许多滞后现象是由非平衡效应和“非物理”模型导致的实验假象。不同的温度步骤使得能够额外计算解吸活化能(45 - 59 kJ mol⁻¹),这与早期关于延迟孔隙扩散过程的研究结果相当吻合。此外,在20℃和40℃下测定了平衡吸附等温线,以比较吸附和解吸焓。两者吻合良好,证实了解吸与吸附没有显著差异。