Roos P J, Neu C P, Hull M L, Howell S M
Biomedical Engineering Graduate Program, University of California at Davis, Davis, CA 95616, USA.
J Orthop Res. 2005 Mar;23(2):327-33. doi: 10.1016/j.orthres.2004.08.002.
Roentgen stereophotogrammetric analysis (RSA) can be used to measure changes in anterior-posterior (A-P) knee laxity after anterior cruciate ligament (ACL) reconstruction. Previous measurements of A-P knee laxity using RSA have employed a tibial coordinate system with the origin placed midway between the tips of the tibial-eminences. However, the precision in measuring A-P knee laxity might be improved if the origin was placed on the flexion-extension axis of rotation of the knee. The purpose of this study was to determine whether a center-of-rotation tibial coordinate system with the origin placed midway between the centers of the posterior femoral condyles, which closely approximates the flexion-extension center-of-rotation of the knee, improves the precision in measuring A-P knee laxity compared to the tibial-eminence-based coordinate system. A-P knee laxity was measured using each coordinate system six times in three human cadaveric knees implanted with 0.8-mm diameter tantalum markers. For each laxity measurement, the knee was placed in a custom loading apparatus and biplanar radiographs were obtained while the knee resisted a 44 N posterior shear force and 136 N anterior shear force. A-P knee laxity was determined from the change in position of the tibia, with respect to the femur, resulting from the posterior and anterior shear forces. The precision for each coordinate system was calculated as the pooled standard deviation of A-P knee laxity measurements. The precision of the center-of-rotation coordinate system was 0.33 mm, which was about a factor of 2 better than the 0.62 mm precision of the tibial-eminence coordinate system (p=0.006). The 0.33 mm precision with the center-of-rotation coordinate system suggests that an observed change of either 0.56 mm (i.e. 1.7 standard deviations) or greater in A-P knee laxity over time is a real change and not due to measurement error when the new tibial coordinate system is used and other factors contributing to variability are controlled as was done in this study. Accordingly, clinicians and researchers should consider the use of this alternate tibial coordinate system when making serial measurements of A-P knee laxity using RSA because the improved precision allows for the observation of smaller differences.
X线立体摄影测量分析(RSA)可用于测量前交叉韧带(ACL)重建术后膝关节前后(A-P)方向松弛度的变化。以往使用RSA测量膝关节A-P方向松弛度时,采用的胫骨坐标系原点位于胫骨髁间嵴尖端之间的中点。然而,如果将原点置于膝关节屈伸旋转轴上,测量膝关节A-P方向松弛度的精度可能会提高。本研究的目的是确定与基于胫骨髁间嵴的坐标系相比,原点位于股骨后髁中心之间中点的旋转中心胫骨坐标系是否能提高测量膝关节A-P方向松弛度的精度。在三个植入了直径0.8毫米钽标记物的人体尸体膝关节中,分别使用每个坐标系测量膝关节A-P方向松弛度六次。对于每次松弛度测量,将膝关节置于定制的加载装置中,在膝关节抵抗44 N后向剪切力和136 N前向剪切力时获取双平面X线片。根据后向和前向剪切力作用下胫骨相对于股骨位置的变化来确定膝关节A-P方向松弛度。每个坐标系的精度通过A-P方向膝关节松弛度测量的合并标准差来计算。旋转中心坐标系的精度为0.33毫米,比胫骨髁间嵴坐标系的0.62毫米精度约好2倍(p = 0.006)。旋转中心坐标系0.33毫米的精度表明,当使用新的胫骨坐标系且如本研究中那样控制了导致变异性的其他因素时,随着时间推移观察到的膝关节A-P方向松弛度变化达到0.56毫米(即1.7个标准差)或更大是真实变化,而非测量误差所致。因此,临床医生和研究人员在使用RSA对膝关节A-P方向松弛度进行连续测量时应考虑使用这种替代的胫骨坐标系,因为提高的精度能够观察到更小的差异。