Murata H, Chimori H, Hamada T, McCabe J F
Department of Prosthetic Dentistry, Graduate School of Biomedical Sciences, Hiroshima University, 1-2-3 Kasumi, Minami-ku, Hiroshima, 734-8553, Japan.
J Dent Res. 2005 Apr;84(4):376-81. doi: 10.1177/154405910508400416.
Formation of tissue conditioners is a process of polymer chain entanglements. This study evaluated the influence of composition and structure on dynamic viscoelasticity of concentrated polymer solutions based on poly(ethyl methacrylate) (PEMA) used as tissue conditioners through the sol-gel transition. The hypothesis was that the ethanol content is the most influential factor in determining gelation speed. Rheological parameters were determined with the use of a controlled-stress rheometer. Analysis of variance by orthogonal array L(16)(4(5)) indicated that the strong polar bonding of ethanol (contribution ratio rho = 53.8%; confirming the hypothesis) and molecular weight of polymer powders (rho = 26.7%) had a greater influence on the gelation times of PEMA-based systems than did the molar volume of plasticizers (rho = 9.0%) and concentration of polymers (i.e., powder/liquid ratio) (rho = 4.5%). The results suggest that the gelation of tissue conditioners based on PEMA can be controlled over a wide range by varying the polymer molecular weight, and especially ethanol content.
组织调理剂的形成是一个聚合物链缠结的过程。本研究通过溶胶-凝胶转变,评估了基于聚甲基丙烯酸乙酯(PEMA)用作组织调理剂的浓聚合物溶液的组成和结构对动态粘弹性的影响。假设是乙醇含量是决定凝胶化速度的最具影响力的因素。使用控制应力流变仪测定流变参数。通过正交阵列L(16)(4(5))进行方差分析表明,乙醇的强极性键合(贡献率ρ = 53.8%;证实了假设)和聚合物粉末的分子量(ρ = 26.7%)对基于PEMA的体系的凝胶化时间的影响大于增塑剂的摩尔体积(ρ = 9.0%)和聚合物浓度(即粉液比)(ρ = 4.5%)。结果表明,通过改变聚合物分子量,特别是乙醇含量,可以在很宽的范围内控制基于PEMA的组织调理剂的凝胶化。