Kuldvee Ruth, D'ulivo Lucia, Yohannes Gebrenegus, Lindenburg Petrus W, Laine Minna, Oörni Katariina, Kovanen Petri, Riekkola Marja-Liisa
Laboratory of Analytical Chemistry, Department of Chemistry, P.O. Box 55, FIN-00014 University of Helsinki, Helsinki, Finland.
Anal Chem. 2006 Apr 15;78(8):2665-71. doi: 10.1021/ac052006i.
A novel, open tubular capillary electrochromatographic method was developed for the in vitro oxidation of low-density lipoprotein (LDL) particles. Low-density lipoprotein particles with molar mass of approximately 2.5 MDa yielded a stable stationary phase at temperatures 25 and 37 degrees C and at pH values from 3.2 to 7.4. The quality of the coatings was not influenced by variations in the LDL concentration in the coating solutions (within the range of 2-0.015 mg/mL) with the coating procedure used in the study. Radiolabeled LDL stationary phases and scanning electron microscopy, employed to shed light on the location and coating density of LDL particles on the inner surface of the capillary wall, confirmed the presence of an LDL monolayer and almost 100% coating efficiency (99 +/- 8%). In addition, the radioactivity measurements allowed estimation of the amount of LDL present in a single capillary coating. Capillaries coated with human LDL particles were submitted to different oxidative conditions by changing the concentration of the oxidant (CuSO4), oxidation time, pH value, and temperature. The oxidation procedure was followed with electroosmotic flow mobility, which served as an indicator of the increase in total negative charges of LDL coatings, and by asymmetrical field flow fractionation, which measured the changes in size of the lipoprotein particles. The results indicated that oxidation of LDL was progressing with increasing time, temperature, and concentration of the oxidant as expected. The oxidation process was faster around neutral pH values (pH 6.5-7.4) and inhibited at acidic pH values (pH 5.5 and lower).
开发了一种新型的开放管状毛细管电色谱方法,用于低密度脂蛋白(LDL)颗粒的体外氧化。摩尔质量约为2.5 MDa的低密度脂蛋白颗粒在25和37摄氏度以及pH值为3.2至7.4的条件下产生稳定的固定相。在所研究的涂层过程中,涂层溶液中LDL浓度的变化(在2 - 0.015 mg/mL范围内)不会影响涂层质量。放射性标记的LDL固定相和扫描电子显微镜用于阐明LDL颗粒在毛细管壁内表面的位置和涂层密度,证实存在LDL单分子层且涂层效率几乎达到100%(99±8%)。此外,放射性测量可以估算单个毛细管涂层中LDL的含量。通过改变氧化剂(CuSO4)的浓度、氧化时间、pH值和温度,使涂有人LDL颗粒的毛细管处于不同的氧化条件下。氧化过程通过电渗流迁移率进行跟踪,电渗流迁移率可作为LDL涂层总负电荷增加的指标,同时通过不对称场流分级法测量脂蛋白颗粒大小的变化。结果表明,LDL的氧化如预期那样随着时间、温度和氧化剂浓度的增加而进行。氧化过程在接近中性的pH值(pH 6.5 - 7.4)时更快,而在酸性pH值(pH 5.5及更低)时受到抑制。