Suppr超能文献

带弱聚电解质的带电纳米颗粒悬浮液中的受控缔合

Controlled association in suspensions of charged nanoparticles with a weak polyelectrolyte.

作者信息

Howe Andrew M, Wesley Robin D, Bertrand Magali, Côte Marie, Leroy Julien

机构信息

Kodak European Research, 332 Science Park, Milton Road, Cambridge CB4 0BW, UK.

出版信息

Langmuir. 2006 May 9;22(10):4518-25. doi: 10.1021/la053327s.

Abstract

The properties of high-pH suspensions of mixtures of silica with low-molecular-weight samples of the water-soluble polymer polyethylenimine (PEI) have been studied. At pH > 10 and low ionic strength, silica nanoparticles are stabilized by a negative surface charge, and PEI has only a very low positive charge. The adsorption of PEI induces a localized positive charge on the segments of polymer closest to the silica surface. The parts of the molecule furthest away from the surface have little charge because of the high pH of the medium. The polymer-covered particle remains negatively charged, imparting some electrostatic stabilization. Suspensions of silica and low-molecular-weight PEI are low-viscosity fluids immediately after mixing, but aggregation occurs leading to the eventual gelation (or sedimentation at lower concentrations) of these mixtures, indicating colloidal instability. The gelation time passes through a minimum with increasing surface coverage. The rate of gelation increases exponentially with molecular weight: for molecular weight > or = 10,000 Da PEI, the instability is so severe that uniform suspensions cannot be produced using simple mixing techniques. The gelation rates increase rapidly with temperature, ionic strength, and reduction in pH. The rate of gelation increases with increasing particle concentration at low surface coverage but decreases at high coverage as a consequence of a small increase in pH. Gels are broken by application of high shear into aggregates that re-gel more rapidly than the original discrete coated particles.

摘要

研究了二氧化硅与水溶性聚合物聚乙烯亚胺(PEI)低分子量样品混合物的高pH悬浮液的性质。在pH>10且离子强度较低时,二氧化硅纳米颗粒通过负表面电荷得以稳定,而PEI仅带有非常低的正电荷。PEI的吸附在最靠近二氧化硅表面的聚合物链段上诱导出局部正电荷。由于介质的高pH值,分子中离表面最远的部分电荷很少。被聚合物覆盖的颗粒仍带负电荷,从而提供了一定的静电稳定性。二氧化硅和低分子量PEI的悬浮液在混合后立即是低粘度流体,但会发生聚集,导致这些混合物最终凝胶化(或在较低浓度下沉淀),表明胶体不稳定。凝胶化时间随着表面覆盖率的增加而经过一个最小值。凝胶化速率随分子量呈指数增加:对于分子量≥10,000 Da的PEI,不稳定性非常严重,以至于使用简单混合技术无法制备均匀的悬浮液。凝胶化速率随温度、离子强度和pH值降低而迅速增加。在低表面覆盖率下,凝胶化速率随颗粒浓度增加而增加,但在高覆盖率下,由于pH值略有升高,凝胶化速率会降低。通过施加高剪切力可使凝胶破碎成聚集体,这些聚集体比原始离散的包覆颗粒更快地重新凝胶化。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验