Bouwman A M, Visser M R, Meesters G M H, Frijlink H W
Department of Pharmaceutical Technology and Biopharmacy, Groningen University Institute for Drug Exploration, Ant. Deusinglaan 1, 9713 AV Groningen, The Netherlands.
Int J Pharm. 2006 Aug 2;318(1-2):78-85. doi: 10.1016/j.ijpharm.2006.03.038. Epub 2006 Apr 1.
The objective of this study was three-fold; to investigate the different mechanisms of material exchange during the equilibrium phase of the granulation process and whether these mechanisms are consistent with the mechanisms described in the growth regime map, to study how material properties and process conditions affect these exchange mechanisms, and to correlate Stokes deformation number to the exchange mechanisms. Microcrystalline cellulose (MCC), alpha-lactose, microfine cellulose (MFC), and dextrin were granulated using water as a binding agent. Once in the equilibrium phase, 5% (w/w) of the granular mass was replaced with wet tracer granules, after which the granulation process was continued. Granules were typically of a size of approximately 1mm in diameter. Therefore, these granules can also be called pellets. Tracer experiments show indeed solid material exchange can take place in the equilibrium phase of the high shear granulation process. Tracer material was equally dispersed throughout the whole batch for all materials tested. However, the granulation time needed to reach this homogeneous distribution varied with material and granulation conditions. Three different mechanisms of material exchange were identified: exchange by disintegration, where granules are rapidly crushed and formed to granules again; exchange by deformation, where abraded granule fragments immediately fuse with other granules; and exchange by distribution, where there is a prolonged period over which both tracer and standard granules stay intact, followed by uncontrolled growth and exchange of material. It was found that it is possible to shift between the mechanisms by changing the process conditions, e.g., changing viscosity or amount of binder liquid. These observations indicate that by choosing the appropriate process conditions improved distribution of small amounts of insoluble materials in the granules can be obtained. A relation exists between the exchange mechanisms and the growth regime map: the disintegration mechanism resembles 'crumb behaviour', the deformation mechanism resembles 'steady growth', and the distribution mechanism resembles 'nucleation' and 'induction growth'. Unfortunately, Stokes deformation number cannot be used as a predictive tool when low viscosity binders like water are used, due to the importance of viscosity in the equation. However, this number is one of the variables of the growth regime map. Since the exchange mechanisms correspond to the granule growth mechanisms in the regime map, alternatively colour experiments might be used to reveal the granulation regime.
研究制粒过程平衡阶段物质交换的不同机制,以及这些机制是否与生长区域图中描述的机制一致;研究材料特性和工艺条件如何影响这些交换机制;将斯托克斯变形数与交换机制相关联。使用水作为粘合剂对微晶纤维素(MCC)、α-乳糖、微粉纤维素(MFC)和糊精进行制粒。一旦进入平衡阶段,用湿示踪颗粒替代5%(w/w)的颗粒物料,之后继续制粒过程。颗粒的典型直径约为1mm。因此,这些颗粒也可称为小丸。示踪实验表明,在高剪切制粒过程的平衡阶段确实会发生固体物质交换。对于所有测试材料,示踪物质在整个批次中均匀分散。然而,达到这种均匀分布所需的制粒时间随材料和制粒条件而变化。确定了三种不同的物质交换机制:通过崩解进行交换,即颗粒迅速破碎并再次形成颗粒;通过变形进行交换,即磨损的颗粒碎片立即与其他颗粒融合;通过分布进行交换,即示踪颗粒和标准颗粒在较长时间内保持完整,随后发生不受控制地生长和物质交换。研究发现,可以通过改变工艺条件(例如改变粘度或粘合剂液体的量)在这些机制之间进行转换。这些观察结果表明,通过选择合适的工艺条件,可以使少量不溶性物质在颗粒中获得更好的分布。交换机制与生长区域图之间存在关联:崩解机制类似于“碎粒行为”,变形机制类似于“稳定生长”,分布机制类似于“成核”和“诱导生长”。遗憾的是,当使用水等低粘度粘合剂时,由于粘度在方程中的重要性,斯托克斯变形数不能用作预测工具。然而,这个数字是生长区域图的变量之一。由于交换机制与区域图中的颗粒生长机制相对应,因此也可以使用颜色实验来揭示制粒区域。