Widengren Jerker, Chmyrov Andriy, Eggeling Christian, Löfdahl Per-Ake, Seidel Claus A M
Experimental Biomolecular Physics, Department of Applied Physics, Albanova University Center, Royal Institute of Technology, SE-10691 Stockholm, Sweden.
J Phys Chem A. 2007 Jan 25;111(3):429-40. doi: 10.1021/jp0646325.
Given the particular importance of dye photostability for single-molecule and fluorescence fluctuation spectroscopy investigations, refined strategies were explored for how to chemically retard dye photobleaching. These strategies will be useful for fluorescence correlation spectroscopy (FCS), fluorescence-based confocal single-molecule detection (SMD) and related techniques. In particular, the effects on the addition of two main categories of antifading compounds, antioxidants (n-propyl gallate, nPG, ascorbic acid, AA) and triplet state quenchers (mercaptoethylamine, MEA, cyclo-octatetraene, COT), were investigated, and the relevant rate parameters involved were determined for the dye Rhodamine 6G. Addition of each of the compound categories resulted in significant improvements in the fluorescence brightness of the monitored fluorescent molecules in FCS measurements. For antioxidants, we identify the balance between reduction of photoionized fluorophores on the one hand and that of intact fluorophores on the other as an important guideline for what concentrations to be added for optimal fluorescence generation in FCS and SMD experiments. For nPG/AA, this optimal concentration was found to be in the lower micromolar range, which is considerably less than what has previously been suggested. Also, for MEA, which is a compound known as a triplet state quencher, it is eventually its antioxidative properties and the balance between reduction of fluorophore cation radicals and that of intact fluorophores that defines the optimal added concentration. Interestingly, in this optimal concentration range the triplet state quenching is still far from sufficient to fully minimize the triplet populations. We identify photoionization as the main mechanism of photobleaching within typical transit times of fluorescent molecules through the detection volume in a confocal FCS or SMD instrument (<1-20 ms), and demonstrate its generation via both one- and multistep excitation processes. Apart from reflecting a major pathway for photobleaching, our results also suggest the exploitation of the photoinduced ionization and the subsequent reduction by antioxidants for biomolecular monitoring purposes and as a possible switching mechanism with applications in high-resolution microscopy.
鉴于染料光稳定性对于单分子和荧光涨落光谱研究的特殊重要性,人们探索了如何从化学角度延缓染料光漂白的优化策略。这些策略将对荧光相关光谱法(FCS)、基于荧光的共聚焦单分子检测(SMD)及相关技术有用。特别是,研究了添加两类主要抗褪色化合物(抗氧化剂(没食子酸正丙酯,nPG,抗坏血酸,AA)和三重态猝灭剂(巯基乙胺,MEA,环辛四烯,COT))的影响,并确定了染料罗丹明6G相关的速率参数。在FCS测量中,添加每类化合物均使监测到的荧光分子的荧光亮度有显著提高。对于抗氧化剂,我们确定了一方面还原光离子化荧光团与另一方面还原完整荧光团之间的平衡,作为在FCS和SMD实验中为实现最佳荧光产生而添加何种浓度的重要指导原则。对于nPG/AA,发现该最佳浓度处于低微摩尔范围,这比之前建议的浓度要低得多。此外,对于作为三重态猝灭剂的MEA,最终是其抗氧化性能以及荧光团阳离子自由基还原与完整荧光团还原之间的平衡决定了最佳添加浓度。有趣的是,在这个最佳浓度范围内,三重态猝灭仍远不足以充分最小化三重态粒子数。我们确定在共聚焦FCS或SMD仪器中荧光分子通过检测体积的典型传输时间内(<1 - 20毫秒),光离子化是光漂白的主要机制,并证明其通过单步和多步激发过程产生。除了反映光漂白的主要途径外,我们的结果还表明可利用光致电离以及随后抗氧化剂的还原作用进行生物分子监测,并作为一种可能的切换机制应用于高分辨率显微镜。