Strauss Eric J, Ishak Charbel, Inzerillo Christopher, Walsh Michael, Yildirim Gokce, Walker Peter, Jazrawi Laith, Rosen Jeffrey
Sports Medicine Service, Department of Orthopaedic Surgery, NYU Hospital for Joint Diseases, New York, New York 10003, USA.
Br J Sports Med. 2007 Aug;41(8):481-5; discussion 485. doi: 10.1136/bjsm.2006.030767. Epub 2007 Jan 29.
To determine whether positioning of the tibia affects the degree of tibial external rotation seen during a dial test in the posterior cruciate ligament (PCL)-posterolateral corner (PLC)-deficient knee.
Laboratory investigation.
Biomechanics laboratory.
An anterior force applied to the tibia in the combined PCL-PLC-deficient knee will yield increased tibial external rotation during a dial test.
The degree of tibial external rotation was measured with 5 Nm of external rotation torque applied to the tibia at both 30 degrees and 90 degrees of knee flexion. Before the torque was applied, an anterior force, a posterior force, or neutral (normal, reduced control) force was applied to the tibia. External rotation measurements were repeated after sequential sectioning of the PCL, the posterolateral structures and the fibular collateral ligament (FCL).
Baseline testing of the intact specimens demonstrated a mean external rotation of 18.6 degrees with the knee flexed to 30 degrees (range 16.1-21.0 degrees ), and a mean external rotation of 17.3 degrees with the knee flexed to 90 degrees (range 13.8-20.0 degrees ). Sequential sectioning of the PCL, popliteus and popliteofibular ligament, and the FCL led to a significant increase in tibial external rotation compared with the intact knee for all testing scenarios. After sectioning of the popliteus and popliteofibular ligament, the application of an anterior force during testing led to a mean tibial external rotation that was 5 degrees greater than during testing in the neutral position and 7.5 degrees greater than during testing with a posterior force. In the PCL, popliteus/popliteofibular ligament and FCL-deficient knee, external rotation was 9 degrees and 12 degrees greater with the application of an anterior force during testing compared with neutral positioning and the application of a posterior force, respectively.
An anterior force applied to the tibia during the dial test in a combined PCL-PLC-injured knee increased the overall amount of observed tibial external rotation during the dial test. The anterior force reduced the posterior tibial subluxation associated with PCL injury, which is analogous to what is observed when the dial test is performed with the patient in the prone position. Reducing the tibia with either an anterior force when the patient is supine or performing the dial test with the patient in the prone position increases the ability of an examiner to detect a concomitant PLC injury in the setting of a PCL-deficient knee.
确定在伴有后交叉韧带(PCL)-后外侧角(PLC)损伤的膝关节进行表盘试验时,胫骨的位置是否会影响所观察到的胫骨外旋程度。
实验室研究。
生物力学实验室。
在伴有PCL-PLC损伤的膝关节中,向胫骨施加向前的力会使表盘试验期间胫骨外旋增加。
在膝关节屈曲30度和90度时,对胫骨施加5牛米的外旋扭矩,测量胫骨外旋程度。在施加扭矩之前,向胫骨施加向前的力、向后的力或中立(正常、减少控制)力。在依次切断PCL、后外侧结构和腓侧副韧带(FCL)后,重复进行外旋测量。
完整标本的基线测试表明,膝关节屈曲至30度时平均外旋18.6度(范围16.1 - 21.0度),膝关节屈曲至90度时平均外旋17.3度(范围13.8 - 20.0度)。与完整膝关节相比,在所有测试场景下,依次切断PCL、腘肌和腘腓韧带以及FCL后,胫骨外旋显著增加。切断腘肌和腘腓韧带后,测试期间施加向前的力导致胫骨平均外旋比中立位置测试时大5度,比向后的力测试时大7.5度。在PCL、腘肌/腘腓韧带和FCL损伤的膝关节中,测试期间施加向前的力时,外旋分别比中立位置和施加向后的力时大9度和12度。
在伴有PCL-PLC损伤的膝关节进行表盘试验时,向胫骨施加向前的力会增加表盘试验期间观察到的胫骨外旋总量。向前的力减少了与PCL损伤相关的胫骨后向半脱位,这与患者俯卧位进行表盘试验时观察到的情况类似。患者仰卧时用向前的力固定胫骨或患者俯卧位进行表盘试验,可提高检查者在PCL损伤的膝关节中检测合并PLC损伤的能力。