Suppr超能文献

序批式反应器系统在纺织染料降解中的应用:偶氮染料与酞菁染料的比较

Application of a sequential batch reactor system for textile dyes degradation: comparison between azo and phthalocyanine dyes.

作者信息

Harrelkas F, Pons M N, Zahraa O, Yaacoubi A, Lakhal E K

机构信息

Laboratoire des Sciences du Génie Chimique, CNRS-ENSIC-INPL, BP 20451, F54001 Nancy, France.

出版信息

Water Sci Technol. 2007;55(10):107-14. doi: 10.2166/wst.2007.313.

Abstract

Photocatalysis on supported TiO2 was combined with aerobic biological treatment in a sequential batch reactor to compare the degradation of two textile dyes: a blue azo dye (DR KBL CDG) and a green phthalocyanine dye (DR K4GN). Three reactors were run in parallel. SBR1 was used as a reference and was fed with urban wastewater only. SBR2 and SBR3 were fed with the same urban wastewater combined with pretreated (for SBR2) and non-pretreated (for SBR3) dye solution. For an azo dye concentration of 12 mg/L decolouration yields of 78 and 27% were achieved, respectively, in SBR2 and SBR3. For the phthalocyanine dye, the decolouration yields decreased to 24 and 15%, respectively. Concerning COD removal it decreases for both dyes with and without pretreatment, when the dye concentration increases. Although a detrimental effect on biomass could be observed, bacteria were able to cope with the inhibitory effect of the dyes.

摘要

在序批式反应器中,将负载型TiO₂上的光催化与好氧生物处理相结合,以比较两种纺织染料的降解情况:一种蓝色偶氮染料(DR KBL CDG)和一种绿色酞菁染料(DR K4GN)。三个反应器并行运行。SBR1用作参考,仅加入城市污水。SBR2和SBR3加入相同的城市污水,并分别加入经过预处理(SBR2)和未经过预处理(SBR3)的染料溶液。对于浓度为12 mg/L的偶氮染料,SBR2和SBR3中的脱色率分别达到78%和27%。对于酞菁染料,脱色率分别降至24%和15%。关于化学需氧量(COD)的去除,当染料浓度增加时,无论有无预处理,两种染料的COD去除率均下降。尽管可以观察到对生物量有不利影响,但细菌能够应对染料的抑制作用。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验