Sawyer Laura J, Evans Martyn J, Hiscock Sarah C
Department of Medical Physics and Bioengineering, Royal United Hospital, Bath, UK.
Nucl Med Commun. 2007 Aug;28(8):631-6. doi: 10.1097/MNM.0b013e328274207c.
The use of 90Y for nuclear medicine therapies has steadily increased over the last 10 years. High administered activities are measured in a calibrated re-entrant ionization chamber, while the most sensitive method of assessment of low activities uses a liquid scintillation counter. This method requires the samples to have an acceptably low quench, and therefore heavily coloured samples must undergo chemical processing before assessment. An alternative method has been investigated to measure low activities of 90Y in a sodium iodide well counter by detection of associated Bremsstrahlung.
Test samples of 90Y with activities 0.5-730 Bq were measured in a well counter and a liquid scintillation counter, with counting times of 4 h per sample. Both counters were investigated for a relationship between count rate and activity.
The efficiency of the well counter was found to be 0.08 count x s(-1) x Bq(-1), for a specified vial and sample volume. This is poor compared with the liquid scintillation counter efficiency of 1.0 count x s (-1) x Bq(-1). The uncertainty in measurement of a sample with unknown activity was calculated for a 4 h count time: +/-8.0% at 730 Bq and +/-45% at 6 Bq for the well counter; and +/-8.0% and +/-8.1%, respectively, for the liquid scintillation counter. These errors are dominated by the initial measurement of activity to determine counting efficiency, using a calibrator with an accuracy of +/-8%. If long counting times of both samples and background radiation are practicable, it has been found that a well counter can successfully be used to assess low activities of 90Y.
在过去10年中,90Y用于核医学治疗的情况稳步增加。高给药活度在经过校准的重入式电离室中测量,而评估低活度最灵敏的方法是使用液体闪烁计数器。这种方法要求样品具有可接受的低猝灭,因此颜色较深的样品在评估前必须经过化学处理。已经研究了一种替代方法,通过检测相关的轫致辐射,在碘化钠井型计数器中测量90Y的低活度。
对活度为0.5 - 730 Bq的90Y测试样品在井型计数器和液体闪烁计数器中进行测量,每个样品的计数时间为4小时。研究了两个计数器的计数率与活度之间的关系。
对于特定的样品瓶和样品体积,发现井型计数器的效率为0.08计数×秒(-1)×贝克勒尔(-1)。与液体闪烁计数器1.0计数×秒(-1)×贝克勒尔(-1)的效率相比,这一效率较低。对于4小时的计数时间,计算了未知活度样品测量的不确定度:井型计数器在730 Bq时为±8.0%,在6 Bq时为±45%;液体闪烁计数器分别为±8.0%和±8.1%。这些误差主要由使用精度为±8%的校准器来确定计数效率的初始活度测量所主导。如果样品和本底辐射的长计数时间可行,已发现井型计数器可成功用于评估90Y的低活度。