Wang Xiao-feng, Chen Bai-cheng, Shi Chen-xia, Gao Shi-jun, Shao De-cheng, Li Tong, Lu Bo, Chen Jing-qing
Department of Orthopaedics, the Third Hospital of Hebei Medical University, Shijiazhuang 050051, China.
Zhonghua Wai Ke Za Zhi. 2007 Jun 15;45(12):839-42.
To compare the effects of increased posterior tibial slope or partial posterior cruciate ligament (PCL) release on knee kinematics of total knee arthroplasty (TKA).
Anteroposterior laxity, rotational laxity, varus and valgus laxity and maximum flexion angle were evaluated in 6 normal cadaver knees and the knees after TKA at flexion 0 degrees , 30 degrees , 60 degrees , 90 degrees and 120 degrees . Then the femoral prosthesis was shifted 5 mm posteriorly to simulate the tightly implanted knee. The same tests were performed on the tightly implanted knees. After that, the posterior tibial slope was increased 4 degrees or the PCL was partially released, and the same tests were made as in the normal knees respectively. Statistical analysis of the results was made using student's t test.
Anteroposterior laxity, rotational laxity and varus and valgus laxity of the tightly implanted knees at flexion 30 degrees , 60 degrees , 90 degrees and 120 degrees were significantly less than those of the normal TKA knees (P < 0.05). Compared with the tightly implanted knees, anteroposterior laxity, rotational laxity and varus and valgus laxity at flexion 30 degrees , 60 degrees , 90 degrees and 120 degrees significantly improved after increased 4 degrees posterior tibial slope (P < 0.05); in the partial PCL released group, anteroposterior laxity at flexion 30 degrees , 60 degrees , 90 degrees and 120 degrees was significantly improved (P < 0.05), varus and valgus laxity was significantly improved only at flexion 90 degrees (P < 0.05), and rotational laxity was significantly improved at flexion 30 degrees , 60 degrees and 90 degrees (P < 0.05). Compared with PCL released group, varus and valgus laxity at flexion 30 degrees , 60 degrees and 90 degrees and rotational laxity at flexion 0 degrees , 30 degrees , 60 degrees and 90 degrees were significantly improved in the group of increased 4 degrees posterior tibial slope (P < 0.05). Maximum flexion angle of the tightly implanted knee (120.4 degrees ) was less than that of the normal TKA knees (130.3 degrees , P < 0.05) and that of increased 4 degrees posterior tibial slope group (131.1 degrees , P < 0.05). There was no significant difference at the maximum flexion angle between the increased 4 degrees posterior tibial slope group and the PCL released group (131.1 degrees vs 124.0 degrees , P = 0.0816).
Anteroposterior laxity, varus and valgus laxity, rotational laxity and maximum flexion angle of the tightly implanted knees are less than those of the normal TKA knees. After increased 4 degrees posterior tibial slope, these indexes are improved significantly. Partial PCL released can significantly improve the anteroposterior laxity and had less effect on the varus and valgus laxity, rotational laxity and maximum flexion angle. So, a knee that is tight in flexion can be more likely to be corrected by increasing posterior tibial slope than by partially releasing PCL.
比较增加胫骨后倾角度或部分后交叉韧带(PCL)松解对全膝关节置换术(TKA)膝关节运动学的影响。
对6个正常尸体膝关节以及TKA术后膝关节在0°、30°、60°、90°和120°屈曲位时的前后向松弛度、旋转松弛度、内翻和外翻松弛度以及最大屈曲角度进行评估。然后将股骨假体向后移位5 mm以模拟紧密植入的膝关节。对紧密植入的膝关节进行相同测试。之后,将胫骨后倾角度增加4°或部分松解PCL,并分别对其进行与正常膝关节相同的测试。采用学生t检验对结果进行统计学分析。
紧密植入的膝关节在30°、60°、90°和120°屈曲位时的前后向松弛度、旋转松弛度以及内翻和外翻松弛度显著小于正常TKA膝关节(P < 0.05)。与紧密植入的膝关节相比,胫骨后倾角度增加4°后,在30°、60°、90°和120°屈曲位时的前后向松弛度、旋转松弛度以及内翻和外翻松弛度均显著改善(P < 0.05);在部分PCL松解组中,30°、60°、90°和120°屈曲位时的前后向松弛度显著改善(P < 0.05),仅在90°屈曲位时内翻和外翻松弛度显著改善(P < 0.05),在30°、60°和90°屈曲位时旋转松弛度显著改善(P < 0.05)。与PCL松解组相比,胫骨后倾角度增加4°组在30°、60°和90°屈曲位时的内翻和外翻松弛度以及在0°、30°、60°和90°屈曲位时的旋转松弛度显著改善(P < 0.05)。紧密植入膝关节的最大屈曲角度(120.4°)小于正常TKA膝关节(130.3°,P < 0.05)以及胫骨后倾角度增加4°组(131.1°,P < 0.05)。胫骨后倾角度增加4°组与PCL松解组之间的最大屈曲角度无显著差异(131.1°对124.0°,P = 0.0816)。
紧密植入膝关节的前后向松弛度、内翻和外翻松弛度、旋转松弛度以及最大屈曲角度小于正常TKA膝关节。胫骨后倾角度增加4°后,这些指标显著改善。部分PCL松解可显著改善前后向松弛度,对内翻和外翻松弛度、旋转松弛度以及最大屈曲角度影响较小。因此,对于屈曲时过紧的膝关节,增加胫骨后倾角度比部分松解PCL更有可能纠正。