Huang Liping, Zeng Raymond J, Angelidaki Irini
Institute of Environment and Resource, Technical University of Denmark, DK-2800 Lyngby, Denmark.
Bioresour Technol. 2008 Jul;99(10):4178-84. doi: 10.1016/j.biortech.2007.08.067. Epub 2007 Oct 25.
Electricity generation integrated with xylose degradation was investigated in a two-chamber mediator-less microbial fuel cell (MFC). Voltage output followed saturation kinetics as a function of xylose concentration for concentration below 9.7 mM, with a predicted maximum of 86 mV (6.3 mW m(-2) or 116 mW m(-3)) and half-saturation constant (K(s)) of 0.29 mM. Xylose concentrations from 0.5 mM to 1.5 mM resulted in coulombic efficiencies and maximum voltage ranging from 41+/-1.6% to 36+/-1.2% and 55+/-2.0 mV to 70+/-3.0 mV respectively. Xylose degradation rate increased with increasing xylose concentration up to 9.7 mM and the predicted maximum degradation rate was 0.13 mM h(-1) and K(s) of 3.0 mM. Stirring by nitrogen in the anode chamber led to 99+/-2.3 mV maximum voltage (8.4+/-0.4 mW m(-2) or 153+/-7.1 mW m(-3)) and 5.9+/-0.3% coulombic efficiency at MFC running time 180 h, which were respectively 17+/-1.2% and 37+/-1.8%, higher than those without stirring. The COD removal under stirring was 22.1+/-0.3%, which was slightly lower than that of 23.7+/-0.4% under no stirring. However, stirring resulted in 59% lower xylose degradation rate. This work demonstrates that xylose can be used in the MFC for electricity production. Comparatively higher electricity generation and coulombic efficiency can be obtained by adjusting initial xylose concentration and applying stirring in the anode chamber.
在双室无介质微生物燃料电池(MFC)中研究了与木糖降解相结合的发电情况。对于浓度低于9.7 mM的木糖,电压输出遵循饱和动力学,预测最大值为86 mV(6.3 mW m(-2) 或116 mW m(-3)),半饱和常数(K(s))为0.29 mM。0.5 mM至1.5 mM的木糖浓度导致库仑效率和最大电压分别在41±1.6%至36±1.2%以及55±2.0 mV至70±3.0 mV之间。木糖降解速率随木糖浓度增加而增加,直至9.7 mM,预测最大降解速率为0.13 mM h(-1),K(s)为3.0 mM。在阳极室中用氮气搅拌,在MFC运行180小时时,最大电压为99±2.3 mV(8.4±0.4 mW m(-2) 或153±7.1 mW m(-3)),库仑效率为5.9±0.3%,分别比不搅拌时高17±1.2%和37±1.8%。搅拌下的化学需氧量去除率为22.1±0.3%。略低于不搅拌时的23.7±0.4%。然而,搅拌导致木糖降解速率降低59%。这项工作表明木糖可用于MFC发电,可以通过调整初始木糖浓度和在阳极室中进行搅拌来获得相对较高的发电量和库仑效率。