Djerdjev Alex M, Beattie James K
School of Chemistry, University of Sydney, NSW 2006, Australia.
Phys Chem Chem Phys. 2008 Aug 28;10(32):4843-52. doi: 10.1039/b807623e. Epub 2008 Jul 9.
The effects of oil solubility and composition on the zeta potential and drop size of oil-in-water emulsions stabilised by sodium dodecyl sulfate (SDS) were studied by electroacoustics and ultrasonic attenuation. The zeta-potentials of toluene and alkane emulsions were found to decrease (be less negative) as the water solubility of the dispersed oil phase increased. The zeta-potentials also depended on the composition of mixed oils, becoming more negative with increasing mole fraction of an insoluble oil (hexadecane). As the water solubility of the dispersed oil phase increased, the conductance within the Stern layer relative to the diffuse layer (K/K) increased, which is interpreted as due to the displacement of the shear plane further into the diffuse layer. The shear plane was calculated to increase from approximately 0.50 nm at the insoluble oil-water interface (hexadecane) to approximately 2.5 nm at a soluble oil-water interface of toluene. The lowering of the zeta-potentials of the soluble oils is ascribed to the shift of the shear plane into the diffuse layer, resulting in a more diffuse interface. The total surface conductance of the mixed oils was related to the log of the oil solubility and decreased from approximately 7 x 10(-9) Omega(-1) to 3 x 10(-9) Omega(-1) with increasing oil solubility from hexadecane to toluene, respectively. The lower surface conductance at the soluble oil-water interface is attributed to a reduction in the dielectric constant of the water inside of the shear plane, caused by the presence of the soluble oil.
通过电声学和超声衰减研究了油溶性和组成对十二烷基硫酸钠(SDS)稳定的水包油乳液的ζ电位和液滴尺寸的影响。发现甲苯和烷烃乳液的ζ电位随着分散油相的水溶性增加而降低(负性减小)。ζ电位还取决于混合油的组成,随着不溶性油(十六烷)摩尔分数的增加而变得更负。随着分散油相的水溶性增加,斯特恩层内相对于扩散层的电导率(K/K)增加,这被解释为剪切面进一步向扩散层移动的结果。计算得出,剪切面从不溶性油水界面(十六烷)处的约0.50 nm增加到甲苯可溶性油水界面处的约2.5 nm。可溶性油的ζ电位降低归因于剪切面向扩散层的移动,导致界面更加弥散。混合油的总表面电导率与油溶性的对数相关,并且随着油溶性从十六烷增加到甲苯,分别从约7×10^(-9) Ω^(-1)降低到3×10^(-9) Ω^(-1)。可溶性油水界面处较低的表面电导率归因于剪切面内水的介电常数因可溶性油的存在而降低。