Wei Min-jie, Wang Hui, Liu Chun, Ning Da-liang
Department of Environmental Science and Engineering, Tsinghua University, Beijing 100084, China.
Huan Jing Ke Xue. 2008 Jun;29(6):1555-60.
Bioaugmentation with immobilized genetically engineered microorganism (GEM)/conventional activated sludge (CAS) process for treatment of atrazine wastewater was investigated and effects of hydraulic retention time (HRT) on treatment efficiency, activities of GEM were discussed. The results showed that when HRT was 4-24 h, significant removal of atrazine was obtained in the process with bioaugmentation. When the HRT was 24 h, the first stage of the process got best treatment effect: average atrazine removal rate was 96.64% and average atrazine concentration in effluent was 0.56 mg/L. When HRT was changed to 12 h, 8 h or 4 h, the removal rate was 88.59%, 89.79% and 88.61% respectively. The average removal of COD in 4 runs was 72.76%, 64.59%, 66.16% and 65.84% respectively, Significant loss of GEMs was not observed but strong growth activities, formation of biofilm and zoogloea on the surface of immobile particles were observed via scanning electron microscope (SEM). The mechanical stability of the particles remained unchanged after nearly two-month operation.
研究了固定化基因工程菌(GEM)/传统活性污泥(CAS)工艺生物强化处理阿特拉津废水的效果,并探讨了水力停留时间(HRT)对处理效率和GEM活性的影响。结果表明,当HRT为4 - 24 h时,生物强化工艺对阿特拉津有显著去除效果。当HRT为24 h时,该工艺第一阶段处理效果最佳:阿特拉津平均去除率为96.64%,出水阿特拉津平均浓度为0.56 mg/L。当HRT改为12 h、8 h或4 h时,去除率分别为88.59%、89.79%和88.61%。4次运行中COD的平均去除率分别为72.76%、64.59%、66.16%和65.84%。未观察到GEMs的显著损失,但通过扫描电子显微镜(SEM)观察到固定化颗粒表面有较强的生长活性、生物膜和菌胶团形成。经过近两个月的运行,颗粒的机械稳定性保持不变。