Garcia-Gonzalez L, Geeraerd A H, Elst K, Van Ginneken L, Van Impe J F, Devlieghere F
Business Unit Separation and Conversion Technology, Flemish Institute for Technological Research (VITO), B-2400 Mol, Belgium.
Int J Food Microbiol. 2009 Feb 28;129(3):253-63. doi: 10.1016/j.ijfoodmicro.2008.12.005. Epub 2008 Dec 10.
High pressure carbon dioxide (HPCD) treatment is currently considered as an attractive non-thermal process for preserving food. Industrial application of this technique requires, among others, systematic (quantitative) data on the inactivation of food relevant pathogenic and spoilage microorganisms, and in-depth information on the effect that the composition and the properties of a food matrix have on the inactivation efficacy. The first objective of this study, therefore, is to evaluate and compare the HPCD susceptibility of several food pathogens and spoilage microorganisms under the same treatment conditions. In the second part, the influence of different food components (NaCl, oil, starch, whey protein and emulsifier) and food properties (pH, fluid viscosity and water activity) on the inactivation efficacy of HPCD was determined. For the first aim, a range of Gram-negative and Gram-positive bacteria, yeasts and spores were treated with pressurized CO(2) at 10.5 MPa and 35 degrees C during 20 min. Bacterial susceptibility towards HPCD treatments followed the sequence Gram-negative approximately Gram-positive>yeasts>spores and appeared to be related to the acid resistance of the organisms. To study the effect of different food compounds on HPCD inactivation, the reduction degree of Pseudomonas fluorescens was determined in media with and without these components at 10.5 MPa and 35 degrees C after 5 or 20 min, depending on the tested component. NaCl and the emulsifiers Tween 80 and sucrose stearate enhanced bacterial reduction, while oil reduced the bactericidal efficacy of HPCD. Starch and whey proteins did not influence inactivation. Finally, the influence of pH, fluid viscosity and water activity was investigated by determining the reduction of P. fluorescens at 10.5 MPa and 35 degrees C in suspensions from which the pH, viscosity and water activity were adjusted with respectively NaOH or HCl, gelatin or polyethylene glycol, and sucrose, NaCl or glycerol. Treatment time depended on the studied food property with 5 min for the pH experiments, while other experiments lasted 20 min. The results indicated that P. fluorescens cells became more sensitive to HPCD treatments at low pH and viscosity. Not water activity but the kind of soluble solute used to lower water activity influenced inactivation. High NaCl-concentrations lead to total inactivation, while sucrose and glycerol strongly protected the cells against inactivation.
高压二氧化碳(HPCD)处理目前被认为是一种极具吸引力的食品保鲜非热加工方法。该技术的工业应用尤其需要有关食品相关致病和腐败微生物失活的系统(定量)数据,以及食品基质的组成和性质对失活效果影响的深入信息。因此,本研究的首要目标是在相同处理条件下评估和比较几种食品病原体及腐败微生物对HPCD的敏感性。在第二部分中,测定了不同食品成分(氯化钠、油、淀粉、乳清蛋白和乳化剂)以及食品性质(pH值、流体粘度和水分活度)对HPCD失活效果的影响。对于第一个目标,一系列革兰氏阴性菌、革兰氏阳性菌、酵母和孢子在10.5兆帕和35摄氏度下用加压二氧化碳处理20分钟。细菌对HPCD处理的敏感性顺序为革兰氏阴性菌≈革兰氏阳性菌>酵母>孢子,且似乎与生物体的耐酸性有关。为了研究不同食品化合物对HPCD失活的影响,根据测试成分,在含有和不含这些成分的培养基中,于10.5兆帕和35摄氏度下处理5分钟或20分钟后,测定荧光假单胞菌的减少程度。氯化钠以及乳化剂吐温80和蔗糖硬脂酸酯可增强细菌减少量,而油会降低HPCD的杀菌效果。淀粉和乳清蛋白不影响失活。最后,通过在分别用氢氧化钠或盐酸、明胶或聚乙二醇以及蔗糖、氯化钠或甘油调节pH值、粘度和水分活度的悬浮液中,于10.5兆帕和35摄氏度下测定荧光假单胞菌的减少量,研究了pH值、流体粘度和水分活度的影响。处理时间取决于所研究的食品性质,pH值实验为5分钟,而其他实验持续20分钟。结果表明,荧光假单胞菌细胞在低pH值和低粘度下对HPCD处理更敏感。影响失活的不是水分活度,而是用于降低水分活度的可溶性溶质的种类。高浓度氯化钠会导致完全失活,而蔗糖和甘油则能强烈保护细胞免受失活影响。