Zhang Lixia, Liu Chengshuai, Zhuang Li, Li Weishan, Zhou Shungui, Zhang Jintao
Department of Chemistry and Environment, South China Normal University, Guangzhou 510006, China.
Biosens Bioelectron. 2009 May 15;24(9):2825-9. doi: 10.1016/j.bios.2009.02.010. Epub 2009 Feb 21.
In this paper, three manganese dioxide materials, alpha-MnO(2), beta-MnO(2), gamma-MnO(2) were tested as alternative cathodic catalysts to platinum (Pt) in air-cathode microbial fuel cells (MFCs). Prepared via hydrothermal method, the manganese dioxides were characterized by X-ray powder diffraction patterns (XRD), the Brunauer-Emmett-Teller (BET) method and their average oxidation states (AOS) were determined by the potential voltammetric titration method. The electro-catalytic activity of MnO(2) in neutral pH solution was determined by linear sweep voltammetry (LSV) and the results showed that all manganese dioxides can catalyze oxygen reduction reaction (ORR) in neutral medium with different catalytic activities. beta-MnO(2) appeared to hold the highest catalytic activity due to its highest BET surface area and AOS. Beta-MnO(2) was further used as cathode catalyst in both cube and tube air-cathode MFCs, in which using Klebsiella pneumoniae (K. pneumoniae) biofilm as biocatalyst and utilizing glucose as a substrate in the anode chamber. It was found that tube MFC produced higher output power, with the maximum volumetric power density of 3773+/-347 mW/m(3), than cube MFC. This study suggests that using beta-MnO(2) instead of Pt could potentially improve the feasibility of scaling up MFC designs for real applications by lowering production cost.
在本文中,测试了三种二氧化锰材料,即α-MnO₂、β-MnO₂、γ-MnO₂,作为空气阴极微生物燃料电池(MFC)中铂(Pt)的替代阴极催化剂。通过水热法制备的二氧化锰采用X射线粉末衍射图谱(XRD)进行表征,采用布鲁诺尔-埃米特-泰勒(BET)法测定其比表面积,并通过电位伏安滴定法测定其平均氧化态(AOS)。通过线性扫描伏安法(LSV)测定了MnO₂在中性pH溶液中的电催化活性,结果表明,所有二氧化锰都能在中性介质中催化氧还原反应(ORR),但催化活性不同。β-MnO₂由于其最高的BET比表面积和AOS,似乎具有最高的催化活性。β-MnO₂进一步用作立方体和管式空气阴极MFC的阴极催化剂,其中在阳极室中使用肺炎克雷伯菌(K. pneumoniae)生物膜作为生物催化剂,并利用葡萄糖作为底物。结果发现,管式MFC产生的输出功率更高,最大体积功率密度为3773±347 mW/m³,高于立方体MFC。这项研究表明,使用β-MnO₂代替Pt可能通过降低生产成本来提高MFC设计扩大规模用于实际应用的可行性。