Zhang Weiya, Sun Yin, Wu Caiying, Xing Jun, Li Jianying
College of Chemistry and Molecular Science, Wuhan University, Wuhan, 430072, China.
Anal Chem. 2009 Apr 15;81(8):2912-20. doi: 10.1021/ac802123s.
Single-walled carbon nanotubes (SWNTs) were functionalized with a hydroxyl-terminated silicone oil (TSO-OH). It is synthesized by the reactions of carbonyl chloride groups on the surface of SWNTs and hydroxyl groups of silicone oil (TSO-OH). The functionalized product SWNTs-TSO-OH was first used as precursor and selective stationary phase to prepare the sol-gel derived poly(SWNTs-TSO-OH) solid-phase microextraction (SPME) fiber for determination of polybrominated diphenyl ethers (PBDEs) in water samples. The possible major reaction of the sol-gel coating process was discussed and confirmed by IR spectra, Raman spectroscopy, and scanning electron microscopy. Some parameters of SPME fiber for the determination of PBDEs were investigated by headspace SPME/gas chromatography with electron-capture detection (HS-SPME/GC-ECD). Compared with the commercial SPME fiber, the new coated fiber showed higher extraction efficiency to PBDEs, better thermal stability (over 340 degrees C), and longer life span (over 200 times). All of these advantages are mainly due to the incorporation of SWNTs, which enhanced the pi-pi interaction with PBDEs and increased the surface area of extraction in contact with the sample. Moreover, the sol-gel coating technology additionally provided the porous structure of the 3-D silica network and the strong chemical binding provided which also will improve the extraction efficiency. Under optimized conditions, the method detection limits for seven PBDEs were 0.08-0.8 ng/L (S/N = 3) and the precision (RSD, n = 5) was 2.2-7.5% at the 50 ng/L level. The linearity of the developed method is in the range of 5-500 ng/L with coefficients of correlation greater than 0.995. The developed method was successfully applied for the analysis of trace PBDEs in reservoir water and wastewater samples. The recoveries obtained at spiking 50 ng/L were between 74% and 109% (n = 5) for PBDEs in water samples.
单壁碳纳米管(SWNTs)用羟基封端的硅油(TSO-OH)进行功能化处理。它是通过SWNTs表面的羰基氯基团与硅油(TSO-OH)的羟基反应合成的。功能化产物SWNTs-TSO-OH首先用作前驱体和选择性固定相,制备溶胶-凝胶衍生的聚(SWNTs-TSO-OH)固相微萃取(SPME)纤维,用于测定水样中的多溴二苯醚(PBDEs)。通过红外光谱、拉曼光谱和扫描电子显微镜对溶胶-凝胶涂层过程中可能的主要反应进行了讨论和确认。采用顶空固相微萃取/气相色谱-电子捕获检测法(HS-SPME/GC-ECD)研究了用于测定PBDEs的SPME纤维的一些参数。与商用SPME纤维相比,新型涂层纤维对PBDEs具有更高的萃取效率、更好的热稳定性(超过340℃)和更长的使用寿命(超过200次)。所有这些优点主要归因于SWNTs的加入,它增强了与PBDEs的π-π相互作用,并增加了与样品接触的萃取表面积。此外,溶胶-凝胶涂层技术还提供了三维二氧化硅网络的多孔结构以及强大的化学键合,这也将提高萃取效率。在优化条件下,七种PBDEs的方法检出限为0.08-0.8 ng/L(S/N = 3),在50 ng/L水平下的精密度(RSD,n = 5)为2.2-7.5%。所建立方法的线性范围为5-500 ng/L,相关系数大于0.995。所建立的方法成功应用于水库水和废水样品中痕量PBDEs的分析。水样中PBDEs在加标浓度为50 ng/L时的回收率在74%至109%之间(n = 5)。