Uddin Md Tamez, Rukanuzzaman Md, Khan Md Maksudur Rahman, Islam Md Akhtarul
Department of Chemical Engineering and Polymer Science, Shahjalal University of Science & Technology, Sylhet-3114, Bangladesh.
J Environ Manage. 2009 Aug;90(11):3443-50. doi: 10.1016/j.jenvman.2009.05.030. Epub 2009 Jul 9.
Continuous fixed-bed studies were undertaken to evaluate the efficiency of jackfruit leaf powder (JLP) as an adsorbent for the removal of methylene blue (MB) from aqueous solution under the effect of various process parameters like bed depth (5-10cm), flow rate (30-50mL/min) and initial MB concentrations (100-300mg/L). The pH at point of zero charge (pH(PZC)) of the adsorbent was determined by the titration method and a value of 3.9 was obtained. A FTIR of the adsorbent was done before and after the adsorption to find the potential adsorption sites for interaction with methylene blue molecules. The results showed that the total adsorbed quantities and equilibrium uptake decreased with increasing flow rate and increased with increasing initial MB concentration. The longest breakthrough time and maximum MB adsorption were obtained at pH 10. The results showed that the column performed well at low flow rate. Also, breakthrough time and exhaustion time increased with increasing bed depth. The bed-depth service time (BDST) model and the Thomas model were applied to the adsorption of MB at different bed depths, flow rates, influent concentrations and pH to predict the breakthrough curves and to determine the characteristic parameters of the column that are useful for process design. The two model predictions were in very good agreement with the experimental results at all the process parameters studied indicating that they were very suitable for JLP column design.
进行了连续固定床研究,以评估菠萝蜜叶粉(JLP)作为吸附剂在各种工艺参数(如床层深度(5 - 10厘米)、流速(30 - 50毫升/分钟)和初始亚甲基蓝(MB)浓度(100 - 300毫克/升))影响下从水溶液中去除亚甲基蓝的效率。通过滴定法测定吸附剂的零电荷点pH值(pH(PZC)),得到的值为3.9。在吸附前后对吸附剂进行傅里叶变换红外光谱(FTIR)分析,以找到与亚甲基蓝分子相互作用的潜在吸附位点。结果表明,总吸附量和平衡吸附量随流速增加而降低,随初始MB浓度增加而增加。在pH值为10时获得最长的穿透时间和最大的MB吸附量。结果表明,该柱在低流速下性能良好。此外,穿透时间和耗尽时间随床层深度增加而增加。应用床层深度服务时间(BDST)模型和托马斯模型对不同床层深度、流速、进水浓度和pH值下的MB吸附进行预测,以预测穿透曲线并确定对工艺设计有用的柱特征参数。在所有研究的工艺参数下,这两个模型的预测结果与实验结果非常吻合,表明它们非常适合JLP柱设计。