Department of Kinesiology, Auburn University, Auburn, AL 36849-5323, USA.
J Appl Physiol (1985). 2010 Mar;108(3):705-12. doi: 10.1152/japplphysiol.00963.2009. Epub 2009 Dec 24.
The purpose of this research was to develop new techniques to 1) rapidly sample venous O(2) saturation to determine contraction-by-contraction oxygen uptake (Vo(2)), and 2) precisely control the rate and pattern of blood flow adjustment from one chosen steady state to another. An indwelling inline oximeter probe connected to an Oximetrix 3 meter was used to sample venous oxygen concentration ([O(2)]) (via fractional saturation of Hb with O(2)). Data from the Oximetrix 3 were filtered, deconvolved, and processed by a moving average second by second. Computer software and a program written in-house were used to control blood flow with a peristaltic pump. The isolated canine gastrocnemius muscle complex (GS) in situ was utilized to test these techniques. A step change in metabolic rate was elicited by stimulating GS muscles via their sciatic nerves (supramaximal voltage, 8 V; 50 Hz, 0.2-ms pulse width; train duration 200 ms) at a rate of either 1 contraction/2 s, or 2 contractions/3 s. With arterial [O(2)] maintained constant, blood flow and calculated venous [O(2)] were averaged over each contraction cycle and used in the Fick equation to calculate contraction-by-contraction Vo(2). About 5-8 times more data points were obtained with this method compared with traditional manual sampling. Software-controlled pump perfusion enabled the ability to mimic spontaneous blood flow on-kinetics (tau: 14.3 s) as well as dramatically speed (tau: 2.0 s) and slow (tau: 63.3 s) on-kinetics. These new techniques significantly improve on existing methods for mechanistically altering blood flow kinetics as well as accurately measuring muscle oxygen consumption kinetics during transitions between metabolic rates.
1)快速采样静脉血氧饱和度以确定收缩期的摄氧量(Vo(2)),2)精确控制从一个选定的稳定状态到另一个稳定状态的血流调整的速度和模式。使用内置在线血氧计探头连接到 Oximetrix 3 米仪来采样静脉氧浓度([O(2)])(通过 Hb 与 O(2)的分数饱和度)。来自 Oximetrix 3 的数据通过滤波、反卷积和每秒移动平均值进行处理。计算机软件和内部编写的程序用于通过蠕动泵控制血流。利用原位分离的犬腓肠肌复合体(GS)来测试这些技术。通过刺激坐骨神经(最大电压 8 V;50 Hz,0.2-ms 脉冲宽度;刺激持续时间 200 ms)以 1 次/2 s 或 2 次/3 s 的速率对 GS 肌肉进行刺激,引起代谢率的阶跃变化。在动脉[O(2)]保持恒定的情况下,血流和计算出的静脉[O(2)]在每个收缩周期内平均,并用于 Fick 方程计算收缩期的 Vo(2)。与传统的手动采样相比,这种方法获得的数据点大约多 5-8 倍。软件控制的泵灌注使模拟自发血流动力学(tau:14.3 s)以及显著加速(tau:2.0 s)和减速(tau:63.3 s)动力学的能力成为可能。这些新技术极大地改进了现有的机械改变血流动力学以及在代谢率之间过渡期间准确测量肌肉耗氧量动力学的方法。