Suppr超能文献

噬菌体对植物乳杆菌的吸附:生理和环境因素的影响。

Phage adsorption to Lactobacillus plantarum: influence of physiological and environmental factors.

机构信息

Instituto de Lactología Industrial (UNL-CONICET), Facultad de Ingeniería Química, 1 degrees de Mayo 3250, 3000 Santa Fe, Argentina.

出版信息

Int J Food Microbiol. 2010 Apr 15;138(3):270-5. doi: 10.1016/j.ijfoodmicro.2010.01.007. Epub 2010 Jan 28.

Abstract

Bacteriophage infection of lactic acid bacteria (LAB) constitutes one of the major problems in the dairy industry, causing economic losses and a constant risk of low quality and/or unsafe foods. The first step in the phage biology is the adsorption on the host cell surface. In a previous study, a remarkable thermal, chemical and photocatalytic resistance was demonstrated by four phages of Lactobacillus plantarum (ATCC 8014-B1, ATCC 8014-B2, FAGK1 and FAGK2). In the present work, these phages were used to characterize the adsorption process on L. plantarum ATCC 8014. Clearly, the characterization of this process could increase the possibilities of design useful strategies in order to prevent phage infections. The influence of Ca(2+), temperature, pH and physiological cell state on phage adsorption was investigated. Burst sizes of phages ATCC 8014-B1 and ATCC 8014-B2 were 60 and 83 PFU/infective centre, respectively. The four phages exhibited a high infectivity even at pH 4 and pH 11. Calcium or magnesium ions were not indispensable for cell lysis and plaque formation, and more than 99% of phage particles were adsorbed either in the presence or absence of Ca(2+), after 15 min at 37 degrees C. Phage adsorption was only partially affected at 50 degrees C, while reached its maximum between 30 and 42 degrees C. The highest adsorption values (99.9%) were observed from pH 5 to 7, after 30 min at 37 degrees C. Adsorption rates decreased after the thermal inactivation of cells, though, when 20 microg/ml of chloramphenicol was used, adsorption values were similar on treated and untreated cells. All these results showed that the adsorption process was only partially affected by a few conditions: thermally killed host cells, an incubation temperature of 50 degrees C and pH values of 9 and 10. Nevertheless, and unfortunately, those conditions are not commonly applied during fermented food manufacturing, thus restricting highly the application of strategies currently available to reduce phage infections in industrial environments. This work also contributes to increase the currently knowledge on the biological aspects of L. plantarum bacteriophages.

摘要

噬菌体感染乳酸菌(LAB)是乳制品工业面临的主要问题之一,会导致经济损失,并持续存在食品安全风险。噬菌体生物学的第一步是吸附在宿主细胞表面。在之前的研究中,四种植物乳杆菌噬菌体(ATCC 8014-B1、ATCC 8014-B2、FAGK1 和 FAGK2)表现出显著的耐热、耐化学和光催化性。在本工作中,这些噬菌体被用于表征在 L. plantarum ATCC 8014 上的吸附过程。显然,对该过程的表征可以增加设计有用策略以防止噬菌体感染的可能性。研究了 Ca(2+)、温度、pH 和生理细胞状态对噬菌体吸附的影响。噬菌体 ATCC 8014-B1 和 ATCC 8014-B2 的爆发大小分别为 60 和 83 PFU/感染中心。即使在 pH 值为 4 和 11 时,四种噬菌体也表现出高感染力。钙或镁离子不是细胞裂解和噬菌斑形成所必需的,并且在 37°C 下孵育 15 分钟后,在存在或不存在 Ca(2+)的情况下,超过 99%的噬菌体颗粒被吸附。噬菌体吸附在 50°C 时仅部分受到影响,而在 30 至 42°C 之间达到最大值。在 37°C 下孵育 30 分钟后,在 pH 值为 5 到 7 之间观察到最高的吸附值(99.9%)。然而,在细胞热失活后,吸附速率下降,但是,当使用 20 μg/ml 氯霉素时,处理过的和未处理的细胞上的吸附值相似。所有这些结果表明,吸附过程仅受到少数条件的部分影响:热失活的宿主细胞、孵育温度为 50°C 和 pH 值为 9 和 10。不幸的是,这些条件在发酵食品制造过程中并不常用,因此极大地限制了目前可用于减少工业环境中噬菌体感染的策略的应用。这项工作还增加了对植物乳杆菌噬菌体生物学方面的现有知识。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验