Food Science & Technology Institute, Morinaga Milk Industry Co. Ltd., 1-83, 5-Chome Higashihara, Zama, Kanagawa 252-8583, Japan. k_ihara@morinagamilk
J Dairy Sci. 2010 Jul;93(7):2887-95. doi: 10.3168/jds.2009-3012.
The effects of whipping temperature (5 to 15 degrees C) on the whipping (whipping time and overrun) and rheological properties of whipped cream were studied. Fat globule aggregation (aggregation ratio of fat globules and serum viscosity) and air bubble factors (overrun, diameter, and surface area) were measured to investigate the mechanism of whipping. Whipping time, overrun, and bubble diameters decreased with increasing temperature, with the exception of bubble size at 15 degrees C. The aggregation ratio of fat globules tended to increase with increasing temperature. Changes in hardness and bubble size during storage were relatively small at higher temperatures (12.5 and 15 degrees C). Changes in overrun during storage were relatively small in the middle temperature range (7.5 to 12.5 degrees C). From the results, the temperature range of 7.5 to 12.5 degrees C is recommended for making whipped creams with a good texture, and a specific temperature should be decided when taking into account the preferred overrun. The correlation between the whipped cream strain hardness and serum viscosity was high (R(2)=0.906) and persisted throughout the temperature range tested (5 to 15 degrees C). A similar result was obtained at a different whipping speed (140 rpm). The multiple regression analysis in the range of 5 to 12.5 degrees C indicated a high correlation (R(2)=0.946) in which a dependent variable was the storage modulus of whipped cream and independent variables were bubble surface area and serum viscosity. Therefore, fat aggregation and air bubble properties are important factors in the development of cream hardness. The results of this study suggest that whipping temperature influences fat globule aggregation and the properties of air bubbles in whipped cream, which alters its rheological properties.
研究了搅打温度(5 至 15°C)对搅打(搅打时间和膨胀率)和搅打奶油流变性能的影响。测量了脂肪球聚集(脂肪球的聚集率和血清粘度)和气泡因素(膨胀率、直径和表面积),以研究搅打的机制。除了 15°C 时的气泡大小外,搅打时间、膨胀率和气泡直径随着温度的升高而降低。脂肪球的聚集率有随着温度升高而增加的趋势。在较高温度(12.5 和 15°C)下,储存过程中硬度和气泡大小的变化相对较小。在中间温度范围(7.5 至 12.5°C),储存过程中膨胀率的变化相对较小。从结果来看,推荐在 7.5 至 12.5°C 的温度范围内制作质地良好的搅打奶油,并且在考虑到所需膨胀率时,应决定特定的温度。搅打奶油应变硬度与血清粘度之间的相关性很高(R²=0.906),并且在整个测试温度范围内(5 至 15°C)都保持不变。在不同的搅打速度(140 rpm)下也得到了类似的结果。在 5 至 12.5°C 的范围内进行的多元回归分析表明,相关性很高(R²=0.946),其中一个因变量是搅打奶油的储能模量,独立变量是气泡表面积和血清粘度。因此,脂肪聚集和气泡特性是奶油硬度发展的重要因素。本研究结果表明,搅打温度会影响搅打奶油中的脂肪球聚集和气泡特性,从而改变其流变性能。