Schoen P, Lindhout T
Department of Biochemistry, University of Limburg, Maastricht, The Netherlands.
Blood. 1991 Jul 1;78(1):118-24.
Inhibition of prothrombinase by antithrombin III (ATIII) and heparin was investigated in a continuous-flow system. Phospholipid-coated capillaries, containing phospholipid-bound factor Xa and factor Va, were perfused with 1.0 mumol/L prothrombin and 0.5 nmol/L factor Va. At 25 degrees C and a flow rate of 32 microL/min (shear rate 28 seconds-1) the steady-state rates of prothrombin conversion depended linearly on the surface concentration of prothrombinase up to 2 fmol/cm2. The rate of thrombin generation was 952 +/- 43 (SE) mol/min/mol prothrombinase. When ATIII was included in the perfusate for 10 minutes, the free thrombin concentration at the outlet of the capillary was markedly reduced: a 50% neutralization was obtained at 0.7 mumol/L ATIII. However, the prothrombinase activity was not inhibited, as could be established after a subsequent perfusion with prothrombin and factor Va. At an ATIII concentration typical of normal plasma (2 mumol/L) a slight neutralization of prothrombinase was observed: 10% neutralization following a 10-minute perfusion. During a perfusion with ATIII in the absence of prothrombin, or in its presence with hirudin (2 mumol/L) also included in the perfusate, a more pronounced neutralization of prothrombinase was observed: 40% residual activity was obtained after a 10-minute perfusion. From this observation the suggestion comes forward that thrombin, continuously produced at the surface, consumes ATIII in the boundary layer. In this case the true ATIII concentration in the vicinity of surface-bound prothrombinase will be but a small fraction of the initial ATIII concentration in the bulk fluid. Unfractionated heparin and an ultra-low molecular weight heparin (pentasaccharide) did enhance the ATIII-dependent neutralization of prothrombinase, but to a much lesser extent than observed with small unilaminar phospholipid vesicles as the catalytic sites for prothrombinase assembly. The findings reported here support the notion that regulation of prothrombinase by heparin under in vivo conditions occurs at the stage of its formation, ie, through inhibition of free factor Xa and/or the generation of factor Va, rather than by direct inhibition of the prothrombinase activity.
在连续流动系统中研究了抗凝血酶III(ATIII)和肝素对凝血酶原酶的抑制作用。用含有磷脂结合的因子Xa和因子Va的磷脂包被毛细管灌注1.0 μmol/L凝血酶原和0.5 nmol/L因子Va。在25℃和32 μL/min的流速(剪切速率28秒-1)下,凝血酶原转化的稳态速率在凝血酶原酶表面浓度达到2 fmol/cm2之前与凝血酶原酶表面浓度呈线性关系。凝血酶生成速率为952±43(SE)mol/min/mol凝血酶原酶。当在灌注液中加入ATIII 10分钟时,毛细管出口处的游离凝血酶浓度显著降低:在0.7 μmol/L ATIII时可实现50%的中和。然而,凝血酶原酶活性未被抑制,后续用凝血酶原和因子Va灌注后可证实这一点。在正常血浆典型的ATIII浓度(2 μmol/L)下,观察到凝血酶原酶有轻微中和:灌注10分钟后有10%的中和。在无凝血酶原的情况下用ATIII灌注,或在灌注液中加入水蛭素(2 μmol/L)的情况下用ATIII灌注时,观察到凝血酶原酶有更明显的中和:灌注10分钟后残余活性为40%。基于这一观察结果,有人提出表面持续产生的凝血酶会消耗边界层中的ATIII。在这种情况下,表面结合的凝血酶原酶附近的实际ATIII浓度将只是总体流体中初始ATIII浓度的一小部分。未分级肝素和超低分子量肝素(五糖)确实增强了ATIII对凝血酶原酶的中和作用,但程度远低于以小单层磷脂囊泡作为凝血酶原酶组装催化位点时所观察到的程度。此处报道的研究结果支持这样一种观点,即肝素在体内条件下对凝血酶原酶的调节发生在其形成阶段,即通过抑制游离因子Xa和/或因子Va的生成,而不是直接抑制凝血酶原酶活性。