Suppr超能文献

下颌前突患者正颌手术后不对称的颞下颌关节的应力变化。

Stress change on the temporomandibular joint in mandibular prognathism subjects with asymmetry after orthognathic surgery.

机构信息

Department of Oral and Maxillofacial Surgery, Graduate School of Medicine, Kanazawa University, Kanazawa, Japan.

出版信息

Eur J Orthod. 2010 Oct;32(5):522-9. doi: 10.1093/ejo/cjp143. Epub 2010 Aug 26.

Abstract

The purpose of this study was to evaluate changes in stress on the temporomandibular joint (TMJ) in 80 Japanese subjects (21 males and 59 females, mean age 23.7 years) with mandibular prognathism, with and without asymmetry after orthognathic surgery using the rigid bodies spring model (RBSM). The asymmetric group consisted of 40 subjects whose Mx-Md midline was more than 3 degrees. The remaining 40 subjects formed the symmetric group. The geometry of the stress analysis model was based on frontal cephalograms of the subjects. Menton (Me), the centre point of occlusal force on a line connecting the bilateral buccal cusps of the second molars, and the most lateral, superior, and medial points on the condyle were plotted on a computer display and stress on the condyle was calculated with the two-dimensional RBSM program, Fortran. The degree (force partition) of the resultant force, the direction (angulation), and the displacement (X, Y) of each condyle were calculated and the horizontal displacement (u), the vertical displacement (v), and rotation displacement (theta) of the mandibular body at Me were calculated pre- and post-operatively. The data was analysed using paired and unpaired t-tests. For the vertical (v) and rotational (theta) displacement, the post-operative value was smaller than the pre-operative value (v: P < 0.001, theta: P = 0.0063) in the asymmetric group. For angulation and the X-component, the post-operative value was smaller than that pre-operatively on the deviated (angulation: P = 0.0074, X-component: P = 0.0003) and non-deviated (angulation: P = 0.0024, X-component: P = 0.001) side in the asymmetric group. However, there was no significant difference between the pre- and post-operative value for any parameter in the symmetric group. These findings suggest that surgical correction of mandibular prognathism, with and without asymmetry, could induce an improvement in stress balance on the TMJ in the frontal aspect.

摘要

本研究的目的是使用刚体弹簧模型(RBSM)评估 80 名下颌前突的日本患者(21 名男性,59 名女性,平均年龄 23.7 岁)的 TMJ (颞下颌关节)在接受正颌手术后的应力变化,其中 40 名患者存在不对称,其 Mx-Md 中线大于 3 度。其余 40 名患者形成对称组。应力分析模型的几何形状基于患者的正面头颅侧位片。在计算机显示器上绘制颏部(Me)、连接双侧第二磨牙颊尖的咬合力中心点以及髁突的最外侧、最上和最内侧点,并使用二维 RBSM 程序(Fortran)计算髁突上的应力。计算每个髁突的合力的程度(力分配)、方向(角度)和位移(X、Y),并计算 Me 处下颌体的水平位移(u)、垂直位移(v)和旋转位移(theta)术前和术后。使用配对和非配对 t 检验分析数据。对于垂直(v)和旋转(theta)位移,不对称组的术后值小于术前值(v:P < 0.001,theta:P = 0.0063)。对于角度和 X 分量,不对称组中偏斜侧(角度:P = 0.0074,X 分量:P = 0.0003)和非偏斜侧(角度:P = 0.0024,X 分量:P = 0.001)的术后值小于术前值。然而,对称组中任何参数的术前值和术后值之间均无显著差异。这些发现表明,下颌前突的手术矫正,无论是否存在不对称,都可能导致 TMJ 在额状面的应力平衡得到改善。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验